Electrolux EFC 009.1X Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Campânula de ventilação Electrolux EFC 009.1X. Electrolux EFC 009.1X 14 páginas. Electrolux cooker hood
Imprimir página
Using the hood
The hood has one variable speed motor. For the
best performance, we recommend using the low
speeds in normal conditions and the high
speeds in particular cases of strong odour and
vapour concentration.
We recommend starting up the hood a few
minutes before cooking and keeping it running
until all the odours have been eliminated.
5 MIN
0
1 2 3
F
C
B
E F C D
A
A – Motor OFF button
B – ON button and motor speed selection
button 1 - 2 - 3 - 1 - 2 - . . . .
E – Speed 1 LED
F – Speed 2 LED and grease filter saturation
LED (flashes)
C – Speed 3 LED and carbon filter saturation
LED (flashes)
D – Intensive speed indicator LED
G – Intensive speed ON switch
This speed should be used when the
concentration of cooking fumes or odours
is particularly strong (for example when
frying, cooking fish etc.).
The fast speed will run for about 5 min-
utes and then return to the speed previ-
ously set automatically (1, 2 or 3), or
switch off if no speed was selected. To
turn off the fast speed, before the end of
the 5 minutes, press button A or button B.
H – OFF lamp button
I – ON lamp button
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply for
almost 5 sec. by pulling out the plug. Then plug
it in again and try once more before contacting
the Technical Assistance Service.
0
I
H
G
I
Control devices for the grease
filter and carbon filter
This hood has a device which warns you when
to clean the grease filter or replace the carbon
filter (in the case of the air recircultion version).
This hood is delivered without a carbon filter.
For this reason the warning signal to replace the
carbon filter is not connected.
If the hood will be used for recirculation of air,
with carbon filter, the warning signal have to be
connected as follows: Press the buttons B and G
at the same time for about 3 seconds. The LED
marked F lights up.
When the LED marked C lights up, the warning
signal is connected.
To disconnect the warning signal, press the
buttons B and G at the same time for about 3
seconds until the LED marked C goes out.
Grease filter saturation led
The LED marked F warns you when the grease
filter needs to be cleaned.
This LED flashes to warn you that the grease
filters must be cleaned.
Generally, these must be cleaned after 40 hours
of use.
Read the maintenance instructions provided for
the grease filters.
Carbon filter saturation led
The LED marked C indicates carbon filter needs
to be replaced.
This must be done after approximately 160
hours of use.
Read the instructions provided for replacing the
carbon filter.
To restore the LED for the filter
warnings.
After cleaning of the grease filter and exchange
of the carbon filter, press button A for about 3
seconds until the LED F stops flashing.
Correct ventilation
To have the cooker hood working correctly
the windows in the kitchen should be closed.
In stead a window in an adjacent room
should be open.
35