Dretec BM-201 Manual do utilizador - Página 11
Procurar online ou descarregar pdf Manual do utilizador para Monitor de tensão arterial Dretec BM-201. Dretec BM-201 13 páginas. Arm type
Imprimir páginaABOUT BLOOD PRESSURE
Why does my blood pressure
fluctuate throughout the
day?
1. Individual blood pressure varies
multiple times everyday. It is also affected
by the way you tie your cuff and your
measurement position, so please take the
measurement under the same conditions.
2. If the person takes medicine, the
pressure will vary more.
3. Wait at least 3 minutes for another
measurement.
Why do I get a different
blood pressure at home
compared to the hospital?
The blood pressure is different even
throughout the day due to weather,
emotion, exercise etc, Also, there is the
"white coat" effect, which means blood
pressure usually increases in clinical
settings.
Is the result the same
if measuring on the
right arm?
It is ok for both arms, but there
will be some different results for
different people. We suggest you
measure the same arm every time.
What you need to pay
attention to when you measure
your blood pressure at home:
If the cuff is tied properly.
If the cuff is too tight or too loose.
If the cuff is tied on the upper arm.
If you feel anxious.
Taking 2-3 deep breaths before
beginning will be better for
measuring.
Advice: Relax yourself for 4-5
minutes until you calm down.
This section includes a list of error messages and frequently
asked questions for problems you may encounter with your blood
pressure monitor. If the products not operating as you think it
should, check here before arranging for service.
PROBLEM SYMPTOM
CHECK THIS
Batteries are exhausted. Replace with new batteries
Display will not
No power
Batteries are inserted
light up.
incorrectly.
Low
Display is dim or
Batteries are low.
batteries
show
The cuff is not secure.
E 1 shows
E 2 shows
The cuff is very tight
The pressure of the
E 3 shows
cuff is excess.
Error
The monitor detected
motion,talking or the
message
E10 or E11
pluse is too poor
shows
while measuring.
The measurement
process does not detect
E20 shows
the pulse signal.
The treatment of the
E21 shows
measurement failed.
EExx,shows on
A calibration error
the display.
occurred.
TROUBLESHOOTING
REMEDY
Insert the batteries
correctly
Replace with new batteries
Refasten the cuff and then
measure again.
Readjust the cuff ,not too
loose or too tight and then
measure again.
Relax for a moment
and then measure again.
Relax for a
moment and then
measure again.
Loosen the clothing on the
arm and then measure
again
Relax for a moment and
then measure again.
Retake the measurement.
If the problem persists,
contact the retailer or our
customer service
department for further
assistance.Refer to the
warranty for contact
information and return
instructions.