Bosch 6 Series Manual de instruções e instruções de instalação - Página 29

Imprimir página

Bosch 6 Series Manual de instruções e instruções de instalação

Programme default

settings

T he programme default settings are

P r o g r a m m e d e f a u l t s e t t i n g s

displayed and can be changed in the

touch display after the programme is

selected.

You can find an overview of all possible

program settings on the supplementary

sheet for the installation and operating

instructions.

Temperature

Depending on what stage the

programme is in, you can change the

set temperature before and during the

programme.

The maximum temperature that can be

set depends on the programme that has

been selected.

Spin speed

Depending on what stage the

programme is in, you can change the

spin speed (in rpm; revolutions per

minute) before and during the

programme.

Setting 2: No spin; the water is only

drained. The laundry stays wet inside

the drum, e.g. for items that should not

be spun.

The maximum speed that can be set

depends on the model and the

programme that has been selected.

Ready in time

After selecting a programme, the

programme duration is displayed, e.g.

1:51 (in h:min (hours:minutes)).

Before the programme starts, you can

move the time at which the programme

Programme default settings

should be finished backwards, in

increments of 30 minutes and up to a

maximum of 24 h (h=hour).

After the programme starts, the selected

time, e.g. 8.5 h is displayed and counted

down until the washing programme starts.

The duration of the programme is then

displayed.

Note:

he programme duration is

automatically adjusted when the

programme is running. Changes to the

programme default settings or programme

settings, foam detection function,

unbalanced load detection, the load or

soiling may also change the programme

duration

After the programme starts, and while

the selected time is counting down, you

can change this as follows:

Touch the control panel A.

Touch N or M to change the time.

And touch A again.

After starting the programme, while the

programme is running, you can add or

remove laundry if necessary.

~ Page 34

Memory programme

You can save a selected programme with

your favourite settings here.

To store:

Switch on the appliance.

Select a programme.

Change the settings and/or select

additional settings.

Press and hold â on the control panel

for approx. three seconds.

The programme is saved if all of the

settings flash briefly.

To use the saved programme, touch â

briefly after you switch on the appliance.

o change the saved programme, press

and hold â again for approx.

seconds after selecting the new

settings.

three