Bosch B22CS50SNW-01 Reparação geral - Instrução - Página 4

Procurar online ou descarregar pdf Reparação geral - Instrução para Frigorífico Bosch B22CS50SNW-01. Bosch B22CS50SNW-01 41 páginas. Bosch b22cs50snw-01 refrigerator/freezer

Imprimir página

2.2

Check list for installation faults

Observe the ventilation dimensions in the installation

instructions. The air duct must not be obstructed. Non-

observance will impair the refrigeration circuit!

Observe the following points:

Maximum permitted weights of the furniture fronts:

Appliances with 2 cup hinges

Appliances with 3 cup hinges

Appliances with 4 cup hinges

Appliances with flat hinges

The max. load for a flat hinge pair is 45 kg. This includes the

appliance door, the load of the door compartments and the

front panel.

Appliances with cushioned flat hinges

The max. load for a cushioned flat hinge pair is 62,5 kg. This

includes

the

appliance

compartments and the front panel.

In this case, cushioned means that the hinge closes by itself

very slowly from an opening angle of 20°.

The transportation reinforcing strut in the rear area of the

kitchen furniture has not been removed. The rail prevents the

appliance from being inserted and the appliance protrudes

slightly.

The socket (surface type) is situated in the area of the motor

compartment. As a result, the refrigerator cannot be inserted

all the way either. The heat dissipated by the condenser and

173_58300000002379_ara_en_j.doc – 29.04.14

9 kg

15 kg

18 kg

door,

the

load

the

the compressor may be impeded. Heat will build up and impair

the refrigeration circuit.

The screw in the upper installation strip brushes against the

cover panel on the built-under cupboard. The cause of this

fault are incorrect cup bores or an inaccurately dimensioned

mounting rail fitted to the front panel

The front panel is lopsided and brushes against the kitchen

furniture. Re-adjustment is possible only by removing the front

panel and correctly installing the mounting rail.

In isolated cases the cover base is missing from the built-in

cupboard. On the upperside of the appliance the cover plate

can be screwed only to the cupboard panel at the front. The

wood is tearing at this location, the screws slacken and the

appliance is no longer in the correct position.

The upper cupboard panel was not installed correctly and

therefore brushes against the front panel.

A blocked condensation outlet causes water to collect and run

out of the appliance at the front. The furniture base weakens

and the appliance moves up or down. The only remedial

action is to replace the furniture base.

If the appliance has been installed too deeply on the handle

door

side, the front panel strikes the carcass and the door does not

close. If this fault occurs, the depth has not been adjusted on

the appliance foot or has been adjusted too far at the rear.

We recommend a 50 cm wide spirit level and a try square as tools for

checking the correct installation location.

Seite 4 von 41