Atlantic SH6500 Manual de instruções - Página 3

Procurar online ou descarregar pdf Manual de instruções para Bomba de água Atlantic SH6500. Atlantic SH6500 13 páginas.

• Pumps should operate on a designated, 110/120 volt circuit rated at 1 5 Amps (minimum).

• Pump must be protected by a Ground Fault Circuit Interrupter (GFCI).

• Pump must be plugged into a standard, properly grounded, three pronged outlet.

• Do not cut the electrical cable. If a cable with cut insulation or other damage is submerged

in water, there is danger of water seeping into the pump motor and causing a short. This

may result in damage to the pump, electrical shock or fire. Altering the electrical cable in

any way will void the warranty.

• Never move or handle the pump by pulling on the electrical cable. Make sure the electrical

cable does not become excessively bent or twisted, does not rub against a structure in a

way that might damage it, and does not come in contact with heated surfaces.

Operation

• SH-Series pumps are for use in water only. Water temperature should never exceed

95 degrees F.

• SH-Series pumps must not be used to pump salt water, sewage, flammable or corrosive

liquids, greases, oils or food waste.

• Pay careful attention to the water level while the pump is operating. The pump handle must

be fully submersed at all times of operation. The pump must never be allowed to run dry.

• In case of excessive vibration, unusual noise or odor, turn off the power immediately and

consult your nearest dealer.

• The pump has a built-in motor protection system. The following reasons may cause the

pump to stop automatically regardless of water level.

- Motor overheating

- Open-phase operation or

operation under constraint

• Repeating cycles of stopping and restarting will damage the water pump. Do not continue

operation at low lift, low water level, or while the inlet is clogged with debris. Not only will

performance suffer, but also such conditions may cause noise, heavy vibration, and pump failure.

Maintenance and Inspection

• Regular maintenance and inspections are a necessity for continued efficient functioning. If

any abnormal conditions are noticed, refer to the section on Troubleshooting and take

corrective measures immediately.

• Check for any drop in performance. Reduced performance is usually caused by debris

blocking the pump intake.

• Detach the power cable from the receptacle or turn off the power supply (circuit breaker).

• Disconnect the pump discharge and remove the pump from the water.

• Remove any accumulated debris from the surface of the pump, inlet and impeller.

• Do not disassemble the pump for any reason. Disassembly will void the pump warranty.

Refer operating and maintenance problems to a qualified technician.

Winterizing

• Under no circumstances should the pump be left in frozen water.

• When the pump is out of use for an extended period, wash it and dry it thoroughly, then

store it indoors.

- Excessive current

- Change in voltage polarity