Drew & Cole VERTI STEAM PRO Instruções para o utilizador - Página 12

Procurar online ou descarregar pdf Instruções para o utilizador para Utensílios de cozinha Drew & Cole VERTI STEAM PRO. Drew & Cole VERTI STEAM PRO 16 páginas.

Imprimir página

Using the Steamer – TO STEAM

• Pull the steam trigger on the front of the unit for steam

delivery.

• Steam will be released through the holes in the press

plate (the polished stainless steel oval section at the

top front of the unit).

• It will take 2 or 3 seconds for steam to be delivered,

and during this initial period the pump will sound a

little louder than in general use. The noise level will

decrease as the steam flow continues.

• Release the trigger to stop the steam (take your finger

off the trigger).

• The trigger can be locked into the 'on' position (1) by

sliding the centre inner trigger button down (2).

• Slide the centre inner trigger button back up to

release the trigger lock and to stop the steam flow.

• When steaming a garment, the unit does not need to

make direct contact with the fabric.

• Hold the steamer head close to the fabric you want

to treat (2cm away) – the steam passing through the

fabric, relaxes the fibres and the creases will drop out.

• It can improve / speed results by holding the bottom

edge of the garment being treated, to tension the

fabric slightly.

• Take care not to get the steam jet too close to the

hand holding the garment as it will be very HOT.

• It is not essential to have the press pad in place for

garment steaming, however it will help to absorb

excess steam and reduce steam build up in the

environment.

Pull to

tension

2cm away from fabric