Alera Plus AAP-CP110 Instruções de montagem e manual do utilizador

Procurar online ou descarregar pdf Instruções de montagem e manual do utilizador para Mobiliário de interior Alera Plus AAP-CP110. Alera Plus AAP-CP110 1 páginas. Xl series, high back task chair

Imprimir página

Read these instructions before starting; follow assembly

procedures carefully.

1. Install casters ⑦ into each of the legs of the base ⑥.

Be sure each caster is completely inserted into leg for

proper stability.

2. Insert the lift assembly ⑤ into base with tapered-end

down. Secure lift assembly by applying a little downward

pressure. Remove yellow plastic cap from top of lift

assembly. DO NOT PUSH ON BUTTON AT THE TOP!

3. Slide dust cover ⑫ onto lift assembly.

4. Turn seat ② upside down on corner of workbench or

table with back of seat towards you.

5. Attach left and right armrests ③ and ④ to bottom of

seat using three pan head screws with washers ⑧ for

each armrest. Armrest pads should be parallel to sides

of seat. Depending on size of end-user, armrests can be

adjusted close to or away from sides of seat. Tighten

screws securely.

6. Turn back ① upside down and align back bracket with

holes in seat ②. Attach back bracket using four socket

head bolts ⑪ with hex wrench ⑩. Before tightening

make sure gap between seat and back is the same on

both sides. Securely tighten four bolts.

7. Align two holes in back plastic strap with two holes in

seat and securely tighten with two phillips pan head

screws ⑨. Attach back plastic strap on other side of seat

S T E P 1

S T E P 3

ASSEMBLY INSTRUCTIONS

1PC

5PCS

6PCS

S T E P 2

S T E P 4

with remaining two screws ⑨ and make sure all four

screws are securely tightened.

8. Install seat with control assembly ② by aligning hole on

the control with the shaft of lift assembly. Push down

firmly on seat. Handle on control can be pulled up to

raise and lower seat.

6. When sitting on seat, pull up on handle to lower seat. To

raise seat, remove weight from seat and pull on seat

handle.

GENERAL SAFETY INSTRUCTIONS

1. Do not stand on seat.

2. Chair must be on level surface to ensure proper stability.

3. Only use chair when fully assembled.

4. Periodically check fasteners and tighten securely if

needed.

5. Never use chair if it does not perform according to this

manual.

MAINTENANCE

Pneumatic lift in lift assembly is permanently lubricated at

factory and needs no further lubrication. Never lubricate

pneumatic lift.

Do not remove clip from bottom of lift assembly. Contact

1-800-733-4000 immediately if clip is missing or damaged.

PARTS LIST

1PC

4PCS

XL Series

High back task chair

AAP-CP110

1PC

4PCS