Dri-Air Industries HA1500B Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Secador Dri-Air Industries HA1500B. Dri-Air Industries HA1500B 14 páginas. Hot air dryer

INSTALLATION

PROCEDURE

Page 6

DRI-AIR

Open electrical access door on the front of the electrical panel

enclosure box by turning the disconnect off and loosening the

screws on the clamping tabs for the door. Locate the

disconnect by following the operating handle down to the

electrical panel.

Insert the incoming power cable or conduit through the hole

provided on the side of the enclosure.

« use approved wire and fastening means «

Wire incoming power to the top of the disconnect as shown in

the diagrams below.

NOTE:

When 3 wire supplies are used in place of 4 wire supplies,

a control transformer is required.

3 PHASE DRYER INSTALLATION

BEFORE RUNNING DRYER

To check blower motor rotation.......

Turn on the power to the dryer and turn the START/STOP

Actuator on the dryer's electrical panel enclosure and quickly

press the E-STOP button. Observe the cooling fan on the

blower motor. The motor should rotate in a "clockwise"

direction or as shown by the arrows on the blower housing. If

the motor is rotating counterclockwise, switch any two

adjacent supply wires.

Process Air Thermocouple Connection:

The dryer is supplied with a 6' long 0.125" Type J

Thermocouple with a 18 foot armored connecting cable and

compression fitting.

Install the compression fitting into the inlet port of the material

hopper and insert the thermocouple so the tip of the probe is

situated in the center of the air stream and tighten the

compression fitting.

Connect the cable to the thermocouple plug on the side of the

dryer's electrical panel enclosure.

The unit is now ready for operation.

OPERATING MANUAL - HA750-1500B HOT AIR DRYERS

Revision 10/8/02

INDUSTRIES, INC.