Dri-Eaz CMC100 Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Desumidificador Dri-Eaz CMC100. Dri-Eaz CMC100 6 páginas. Dri-eaz cmc100 dehumidifier
Também para Dri-Eaz CMC100: Manual do Proprietário (4 páginas)

Imprimir página

Fig. 6: Remove the pump from the pump

bracket.

3. Locate the pump assemble and remove the four bolts con-

necting it to the drain pan (Fig. 5). Lift the pump free. DO

NOT DISCONNECT ANY INTERNAL ELECTICAL

CABLES.

4. Remove the two bolts holding the pump to the pump brack-

et (Fig. 6). Set bracket aside.

5. Locate the impeller housing on the bottom of the pump as-

sembly. Remove the impeller housing by prying apart one

of the two tabs with a screwdriver (Fig. 7). Once one tab is

released, the housing will come loose and the second tab is

easily released.

6. Inspect the impeller and the housing for dirt and debris.

Wipe clean with a cloth. Use a cotton swab to clean the

blades of the impeller.

7. Reattach the impeller housing to the pump assembly. Be-

fore snapping the housing into place, make sure the O-ring

is in position (Fig. 8) and make sure the housing is properly

aligned as shown (Fig. 9). The drain line and the electrical

cable should be pointing in the same direction.

8. Inspect the drip tray. Wipe clean with a cloth as necessary.

9. Reattach the pump assembly to the pump bracket using the

two bolts.

10. Inspect the coil for dust accumulation. Vacuum excess

Fig. 8: Make sure O-ring is correctly seated

before reassembling impeller.

07-01637F F391-A 2012-01 Warranty 07-01651

Fig. 7: Use a screwdriver to pry open

the impeller housing retaining tabs.

dust, taking care not to damage any components. Clean

coils with Dri-Eaz Coil Cleaner. Be sure to wipe up any

spills.

11. Inspect the filter. Clean in mild soap and water and dry tho-

roughly before reinstalling into the filter panel.

12. Replace the drain line panel. Make sure the drain line is

free of kinks and sharp bends before tightening the screws.

13. Replace the interchangeable panels.

14. Test the CMC100 for proper operation. For operation in-

structions, see your Owner's Manual.

NOTE: Before returning the CMC100 to use, make sure it is

properly leveled and that the end of the drain hose is no more

than 3 ft. (1 m) above the top of the CMC100. See "Keep Unit

Level," p. 2, for instructions.

Fig. 9: Reassemble impeller as shown. Make

sure electrical cables are oriented in the

same direction as the drain tube.

Dri-Eaz Products, Inc.