Electrolux ICON RH30WC60GS Manual de instalação, utilização e cuidados - Página 9

Procurar online ou descarregar pdf Manual de instalação, utilização e cuidados para Campânula de ventilação Electrolux ICON RH30WC60GS. Electrolux ICON RH30WC60GS 22 páginas. 30” et 36” hotte aspirante
Também para Electrolux ICON RH30WC60GS: Catálogo de peças de fábrica (4 páginas), Manual de instalação, utilização e cuidados (21 páginas), Manual de instalação, utilização e cuidados (22 páginas), Brochura e especificações (2 páginas), Manual de utilização e cuidados (44 páginas), (Inglês) Guia de instalação, utilização e cuidados (22 páginas), (Francês) Manual D'installation, Utilisation Et D'entretien (22 páginas)

Mounting the duct cover bracket

The duct bracket should be installed against the

back wall and ush with the ceiling. This bracket will

hold the telescopic duct cover in place at the top

Secur

Secur e the bracket to the wall:

e the bracket to the wall:

Align the marked centerline on the bracket with

the centerline on the wall.

Mark 2 screw hole locations in the wall.

Drill 5/16" pilot holes in the marked locations.

Install wall fastener anchors.

Drive wood screws, by hand, into the fastener to

allow anchors to expand. Remove the screws.

Secure the bracket to the wall with wood screws

and/or fasteners.

Installing the hood

If the duct will vent straight up to the ceiling:

Use level to draw a line straight up, from the

centerline on the template to the ceiling.

Measure at least 4 -3/4 " from the back wall to

the circle center of an 8-½" hole on the ceiling.

W W W W W all ducting

all ducting

If ductwork will vent to rear:

Use a level to draw a line straight up from the

centerline on the template.

Measure at least 23 - 3/4" (the measure might

vary depending on the elbow used) above the

pencil line that indicates the bottom installation

height, to the circle center of an 8-½" diameter

duct hole (Hole may be elongated for duct elbow).

The junction box is located on the top left side of

the hood.

Wiring should enter the back wall at least 20"

above the bottom of the installation height, and

within 5-7/8" and 4-7/8"of the left side of the

centerline.

9 9 9 9 9