Electrolux PLHV42P8CC Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Campânula de ventilação Electrolux PLHV42P8CC. Electrolux PLHV42P8CC 32 páginas. Range hood
Também para Electrolux PLHV42P8CC: Manual do Proprietário (32 páginas), Manual do Proprietário (11 páginas), Manual do Proprietário (32 páginas), Manual do Proprietário (10 páginas)
Imprimir página
Installation
Tools required
for
installation
Screwdriver (p0zidriven°2, t0rx 10and 20)
Allen spanner 4mm
Shifting
spanner
10mm
pipe wrench 318
Electric drill with twist bit O 10 mm
K = Kitchen Height
C = Counter Height (36" standard)
P = Height of Hood Bottom above
counter not less than 30"
A = Canopy Height
H = Hood height your installation
H=K-C-P
S = Chimney Structure Height,
your installation.
S=H-A
Figure 2
_A
C (36"std.)
Pre-lnstallations
Calculations
(see Figure 2)
I. a) Select a hood preference
height P (see Figure 2) that is comfortable
for
the user not lessthan 30".
b) Calculate Hood height your installation
H (see Figure 2). H -- K-C-P.
c) Confirm that H iswithin
the range of min to max H found for your hood.
If not adjust your installation.
d) Calculate Chimney
structure
height
S (use formulas
in Figure 2, and
check dimensions of your hood). Save this calculation
for use later in the
installation.
Preparation
of Mountinq
Surface
- Installing
supports
above
ceiling drywall.
Note: Take into consideration
the hood depth; your hood could be much
deeper than the cooktop.
2.
Mark center lines of cooktop or range on ceiling above. Use centerlines marked
on ceiling to position the mounting template. Note location of hood front, side,
and mounting holes indicated on template.
,
Remove and save template. Cut and remove ceiling drywall. Install suitable
length 2" x 4" lumber between joists to provide chimney mounting points as
shown in Fig. 4 and 5. Use template for dimensions and required clearance.
Make sure to affixthe added lumber firmly and level. Consult a professional if you
have difficulties or your installation is unique. Consult template and Figures 3.
4.5.
Note the weight of the appliance.
(see Table1).
4.
Installan8"exhaustduct.
Femaleendshallbe4-1/2"belowfinishedceilingand
securely fastened to joists. Do not use duct smaller than the transition.
5. Install 1/2" electrical conduit in location marked on template and extend length
S from ceiling.
6.
Install drywall around duct and conduit; then refinish ceiling.
:igure
3
Figure 4
Figure
5