Electrolux WHGL9030CN Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Campânula de ventilação Electrolux WHGL9030CN. Electrolux WHGL9030CN 29 páginas.
Também para Electrolux WHGL9030CN: Manual do utilizador (28 páginas), Manual de instalação (12 páginas), Manual de instalação (12 páginas)
Imprimir página
www.electrolux.com
6
4. CONTROLS
Basic function
Button
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate the lighting
L
system in "courtesy light" mode. The lights are lit at a reduced power
of approximately 5W. This function can be disabled by pressing the
button once again for 2 seconds or by pressing it briefly to switch to
normal lighting mode.
Turns the motor off from whatever speed it is set to.
T1
Press and hold the button for 3 seconds with all the loads turned off
(Motor and Lights), to turn the Activated Charcoal Filter alarm on/off.
T2
Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed two.
Press and hold the button for approximately 2" to turn the Delay
function on and off, that is to say to turn the appliance off after a 20
T3
minute delay. Suitable to complete elimination of residual odours. Can
be activated from the OFF position and from speeds 1, 2, 3. Cannot
be activated with Intensive speed On.
T4
Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for a timed
period of 5 minutes. At the end of the 5 minutes the appliance
T5
will automatically return to the speed that was set before. If the
appliance was turned off at the time of activation, at the end of
the 5 minutes the system will return to speed one.
Press and hold for 4 seconds to reset the filter alarm indicator,
F
shown by flashing of button T1. This procedure can only be
carried out with the motor off.
L T1 T2 T3 T4 T5 F
Indicator lights
Button off
Lights off
Button lit
Lights on
Button lit
Courtesy light on
Button lit
Motor active
Motor inactive
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on
Button on
Speed two on
Buttons flashing
Delay functionActive
(T1+T2 or T3 or T4)
Button on
Button on
Signals the Metal Grease Filter
saturation alarm, indicating that it
is necessary to wash the filters.
Button on
The alarm is triggered after the
Hood has been in operation for 100
working hours.
When this is activated, it signals
the Activated Charcoal Filter
saturation alarm, indicating that
the filter must be changed;
the Metal Grease Filters must
Button flashing
also be washed. The Activated
Charcoal Filter saturation alarm
comes into operation after the
Hood has been working for
200 hours.