Bosch 8 Series Manual de instruções de instalação e utilização - Página 14

Imprimir página

Bosch 8 Series Manual de instruções de instalação e utilização

General information

Electrical connection

Warning

Risk of electric shock!

Components inside the appliance may have sharp

edges. These may damage the connecting cable. Do

not kink or pinch the connecting cable during

installation.

The required connection data can be found on the

rating plate inside the appliance; to do this, remove the

metal mesh grease filter.

Length of the cable: approx. 1.30 m

This appliance complies with the EC interference

suppression regulations.

Warning

Risk of electric shock!

It must always be possible to disconnect the appliance

from the electricity supply. The appliance must only be

connected to a protective contact socket which has

been correctly installed. If the plug is no longer

accessible following installation of the appliance, or a

fixed connection is required, an all-pole isolating switch

must be present on the installation side with a contact

gap of at least 3 mm. The fixed connection must only

be installed by an electrician.

Preparing the units

The fitted unit must be level and have sufficient load-

■

bearing capacity.

The max. weight of the extractor hood is 18 kg.

■

Appliance dimensions and safety clearances

Observe the appliance's dimensions.

■

Comply with the safety clearances.

■

If the installation instructions for the gas cooking

appliances specify a different distance, the largest

distance must always be provided for.

The fitted unit must be heat-resistant up to 90 °C.The

fitted unit must still be sturdy after the cut-outs have

been made.

To install the extractor hood in a wall-hanging

cupboard, the extractor hood must be provided with the

following dimensions:

Width

600 mm

Depth

Min. 320 mm

Depth

Min. 350 mm with lowering frame

Height

Min. 420 mm

Height

Min. 600 mm with CleanAir air recirculation

module

Make the cut-out for the exhaust air pipe. To do this,

make an opening in the top or back panel of the

fitted unit with an additional recess for the power

cord.

If the cabinet base is in place, remove it. Mark the

fastening points on the inside of the cabinet and use

a bradawl to make indentations where the holes are

to be. To help you mark the fastening points, use the

mounting piece provided.