Drill Master 61204 Manual do proprietário e instruções de segurança - Página 11
Procurar online ou descarregar pdf Manual do proprietário e instruções de segurança para Serra Drill Master 61204. Drill Master 61204 16 páginas. 120 volt 6" cut-off saw
Também para Drill Master 61204: Manual do proprietário e instruções de segurança (16 páginas)
Imprimir página
troubleshooting
problem
Tool will not start.
1. Cord not connected.
2. No power at outlet.
3. Internal damage or wear. (Carbon
Tool operates slowly. Extension cord too long or
wire size too small.
Performance
1. Wheel worn or dull.
decreases over time.
2. Carbon brushes worn or damaged.
Excessive noise
Internal damage or wear. (Carbon
or rattling.
Brushes or bearings, for example.)
Overheating.
1. Forcing machine to work too fast.
2. Wheel worn or dull.
3. Blocked motor housing vents.
4. Motor being strained by long or
Follow all safety precautions whenever diagnosing or servicing
the tool. Disconnect power supply before service.
61204
possible causes
Brushes or switch, for example.)
small diameter extension cord.
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker.
If breaker is tripped, make sure circuit is right
capacity for tool and circuit has no other loads.
3. Have technician service tool.
Eliminate use of extension cord.
If an extension cord is needed, use one
with the proper diameter for its length and
load. See table a on page 3.
1. Keep cutting accessories sharp.
Replace wheel as needed.
2. Have technician replace brushes.
Have technician service tool.
1. Allow machine to work at its own rate.
2. Keep cutting accessories sharp.
Replace wheel as needed.
3. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
4. Eliminate use of extension cord.
If an extension cord is needed, use one with
the proper diameter for its length and load.
See table a on page 3.
Page 11