Drill Master Drill Master 6" Cut-Off Saw Manual do proprietário e instruções de segurança - Página 10

Procurar online ou descarregar pdf Manual do proprietário e instruções de segurança para Serra Drill Master Drill Master 6" Cut-Off Saw. Drill Master Drill Master 6" Cut-Off Saw 17 páginas. 6" cut-off saw

Imprimir página

maintenance and Servicing

procedures not specifically explained in this manual must

be performed only by a qualified technician.

tO pRevent SeRiOuS injuRY FROm aCCiDental OpeRatiOn:

Release the trigger and unplug the tool from its electrical outlet before

performing any inspection, maintenance, or cleaning procedures.

tO pRevent SeRiOuS injuRY FROm tOOl FailuRe:

Do not use damaged equipment. if abnormal noise or vibration

occurs, have the problem corrected before further use.

Cleaning, maintenance, and lubrication

1. BeFORe eaCh uSe, inspect the general

condition of the tool. Check for:

• loose hardware,

• misalignment or binding of moving parts,

• cracked or broken parts,

• damaged electrical wiring, and

• any other condition that may

affect its safe operation.

Changing Carbon Brushes

Carbon Brush location

Figure D

The two Carbon Brushes are located on either

side of the back of the Saw near the Base.

2. Remove the Caps with a Screwdriver

(sold separately).

Cut-off Wheel Storage and handling

1. Handle Cut-off Wheels carefully to prevent

dropping or bumping. Do not use wheels

that have been dropped or bumped.

Page 10

Cap

For technical questions, please call 1-800-444-3353.

2. aFteR uSe, wipe external surfaces

of the tool with clean cloth.

3. Check and change the Carbon Brushes as needed.

WaRninG! if the supply cord of this

power tool is damaged, it must be replaced

only by a qualified service technician.

3. Slide out the Carbon Brushes, noting the

direction of wear of each brush.

4. If they are worn to 3mm or less

they need to be replaced.

5. Insert new Carbon Brushes and

secure in place with the Caps.

6. If they are still in good condition, replace

the brushes in the same orientation and

secure in place with the Caps.

note: When replacing Carbon Brushes,

always replace both brushes.

2. Store Cut-off Wheels in shelves, racks, boxes, or

drawers. Storage area must be kept dry, and above

freezing. Any grinding or cut-off wheels exposed to

humidity or freezing temperatures must not be used.

Item 69438