Drill Master 61311 Manual do proprietário e instruções de segurança - Página 7
Procurar online ou descarregar pdf Manual do proprietário e instruções de segurança para Lixadeira Drill Master 61311. Drill Master 61311 12 páginas. 120 volt orbital hand sander
Imprimir páginaSpecifications
Setup - Before use:
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the Switch is in the off-position and unplug the tool from its
electrical outlet before assembling or making any adjustments to the tool.
note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 11.
assembly
Dust collection Setup
1. Turn the Dust Chute so that the tab on top of the
rectangular end faces up. Snap it in place into
the rectangular shaft at the back of the Sander.
2. Connect a 1-1/2" dust collection hose from
the Dust Chute to your dust collection
system (hose and system not included).
Use the Dust Connector (if needed).
3. The Dust Chute will only work if the sandpaper
has holes that line up with the 6 dust collection
holes in the Backing Pad. (There are 4 other
holes in the Backing Pad for screws.)
Item 61311
Electrical Rating
No Load Speed
Sandpaper Pad
Dust Chute
For technical questions, please call 1-888-866-5797.
120VAC / 60Hz / 1A
12,000 OPM
4" W x 4-1/2" L
1-1/4" OD
Functions
Switch
Backing
pad
power cord
Dust chute
clamp
Page 7