CP700 COMMERCIAL
POWER AMPLIFIER
SPEAKER OUTPUT WIRING
Low Impedance Direct Coupled Output (Stereo)
For direct coupled operation into 2, 4, and 8 Ohm loads, connect the loudspeaker leads to the barrier strip
connections labeled "Direct Output"; connect the hot lead to the "+" terminal and the common lead to
the "-" terminal. The use of heavy gauge wiring is recommended to avoid voltage drops, resulting in
wasted power in the cable. Contact Atlas Sound Tech Support (1-800-876-3333) for suggestions on cable
capacities. Be sure you know the quantity of speakers and cable lengths before calling (Figure 5).
Low Impedance Direct Coupled Output (Parallel Mono)
Observe the speaker connection information in the preceeding paragraph (Stereo Direct Coupled Output).
With the CP700 turned OFF, move the rear mounted selector switch to the "Parallel" position and connect
your mono input wiring to either the channel one or channel two inputs. Both channels will be driven from
this mono signal (Figure 6).
THRU
GND
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •
©2005 ATLAS SOUND LP
To direct coupled
loudspeakers
To direct coupled
loudspeakers
IN
AMPLIFIER INPUTS
CH-2
CH-1
+
-
GND
-
LEVEL
PARALLEL
Specifications are subject to change without notice
AtlasSound.com
Printed in U.S.A.
CH-1
8, 4, and 2 Ohms
+
-
D I R . O U T P U T
+
BRIDGE
MONO
CH-2
8, 4, and 2 Ohms
+
-
D I R . O U T P U T
-
BRIDGE
MONO
White
Black
Shield
IN
+
THRU
LEVEL
STEREO
BRIDGE
TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
OWNER'S MANUAL
CH-1
AUDIO TRANSFORMER
0
70
100
I S O L . O U T P U T
-
+
-
+
70V
25V
- 100V +
CH-2
AUDIO TRANSFORMER
0
70
100
I S O L . O U T P U T
-
+
-
+
70V
25V
- 100V +
Figure 5
Optional Jumpers
See Note on Page 6
Switch set
to Parallel
Figure 6
ATS002102 RevC 9/05
PP
9
Imprimir página