Bosch Series 4 Manual de instruções de instalação e utilização - Página 13

Imprimir página

Bosch Series 4 Manual de instruções de instalação e utilização

Electrical connection

Warning – Risk of electric shock!

Components inside the appliance may have sharp

edges. These may damage the connecting cable. Do

not kink or pinch the connecting cable during

installation.

The required connection data can be found on the

rating plate inside the appliance; to do this, remove the

metal mesh grease filter.

Length of the cable: approx. 1.30 m

This appliance complies with the EC interference

suppression regulations.

Warning – Risk of electric shock!

It must always be possible to disconnect the appliance

from the electricity supply. The appliance must only be

connected to a protective contact socket that has been

correctly installed.

The mains plug of the mains power cable must be

easily accessible after installation of the appliance. If

this is not possible, an all-pole isolating switch must be

integrated into the permanent electrical installation

according to the conditions of overvoltage category III

and according to the installation regulations.

The permanent electrical installation must only be wired

by a professional electrician. We recommend installing

a residual-current circuit breaker (RCCB) in the

appliance's power supply circuit.

5Installation

F itting the upper support frame

I n s t a l l a t i o n

Before fitting, determine the total height of the

support frame and mark the screw holes.

The height of the support frame can be

Note:

adjusted in 20 mm intervals.

On the ceiling, mark the centre point of the

appliance.

Using the enclosed template, mark the positions for

the screws on the ceiling.

Drill four 8 mm diameter holes to a depth of 80 mm

for the fasteners and press in the wall plugs flush

with the ceiling.

Fasten the upper part of the support frame to the

ceiling with 4 screws.

Ensure that the support frame is in the correct

Note:

position. The middle bracket defines the preferred

side and must be facing the hob control elements.

Installation