Bose AM-30P Manual de serviço - Página 23

Procurar online ou descarregar pdf Manual de serviço para Altifalantes Bose AM-30P. Bose AM-30P 49 páginas.

DISASSEMBLY/ASSEMBLY PROCEDURES
Note: Numbers in parentheses correspond
to the callouts in the Figures referred to in
the following procedures.

2. Cover Replacement

2.1 Place the cover (1) over the module
assembly (18). Align the cover so that the
Main PCB input and output connectors are
inserted into the holes of the cover. Refer to
Figure 14.
2.2 Rotate the tab of the cover latch out
from the enclosure. Refer to Figure 13 and
15.
2.3 Slide the cover over the base-plate (4)
(refer to Figure 16.) until the back of the
cover snaps over the base-plate tabs.
Refer to Figures 12 and 13.
2.4 Use a flat-head screwdriver or scribe to
rotate (to the left) the cover latch tab (3)
back into the enclosure.
2.5 Attach the two tone control knobs (2)
by pushing them in towards the module.
They are keyed and will only fit one way.
Refer to Figure 14.

3. Main PCB Assembly Removal

Note: Refer to Figures 14 and 16 for this
procedure.
3.1 Perform procedure 1.
3.2 Remove the two screws (7) securing
the main PCB (5) to the adapter bracket
(6).
3.3 Disconnect the transformer's 5-pin
connector from J7, the 8-pin cable from the
amplifier, and the flat ribbon cable (8) from
connector J8 on the main PCB.
3.4 Release the main PCB (5) from the
four snaps of the adapter bracket (6).

4. Main PCB Assembly Replacement

4.1 Place the main PCB (5) onto the
adapter bracket (6) component side down.
The J5, J9, and J11 input and output
connectors should be facing the label side
of the module.
4.2 Press the main PCB into the adapter
bracket's (6) four snaps.
4.3 Secure the main PCB to the adapter
bracket by tightening two screws (7).
4.4 Connect the transformer's 5-pin cable
to J7, connect the 8-pin cable from the
amplifier's PCB to J10, and the flat ribbon
cable (8) to J8 on the main PCB.
4.5 Perform procedure 2.

5. Amplifier PCB Removal

5.1 Perform procedure 3.
5.2 Remove four silver screws (7) and
eight black screws (17) securing the
adapter bracket (6) to the base plate (4).
Lift the bracket away from the enclosure.
5.3 Disconnect the transformer's 5-pin
cable from the amplifier PCB's J1 connec-
tor. Disconnect the woofer harness connec-
tor (9) from the amplifier PCB's J3 connec-
tor. Disconnect the flat ribbon cable (8)
from the amplifier PCB's J2 connector.
23