Bose AM267565 Manual do utilizador - Página 20

Procurar online ou descarregar pdf Manual do utilizador para Altifalantes Bose AM267565. Bose AM267565 34 páginas. Bose corporation user guide speaker am267565

Imprimir página

Steps to Installing

Figure 21

Removing the speaker

frame to reorient it as

needed

Note: To position the logo right-side-up if you insert the speaker upside-down, remove the

outer frame from the face of the speaker, rotate it 180˚, then reattach the frame. There are four

speaker frame screws, labeled GRILLE, that hold the frame in place. They should not be con-

fused with the dogleg clamp screws that are labeled WALL (Figure 21). Those screws hold

the dogleg clamps on the frame.

Logo

• If you cannot insert the entire length of the wire straight up in an interior wall, and

sweep it from side to side as shown on the template, you need to drill a new pilot hole

elsewhere. Then repeat the preceding steps 3, 4, and 5.

Repairing a pilot hole

If you need to patch the pilot hole, you can ﬁll it with spackle. You may need to let the spackle

dry, then add more until the hole is slightly overﬁlled. When it is thoroughly dry, sand the area

to bring it back ﬂush with the wall.

Passing the pilot hole test

If you have successfully determined that this location will work for one speaker, test the wall

or ceiling for the second speaker before making any larger holes. Refer to "Drill a pilot hole for

testing the wall space" starting on page 15 and repeat those steps.

If the location for the ﬁrst speaker is ﬁne, but the second is not, you may want to relocate

both speakers.

Round-faced speakers require additional clearance holes on either side of the main

speaker hole. If you have marked but have not drilled those holes yet, do so when it is clear

you will be installing a speaker in that spot.

AM267565_01_V.pdf May 13, 2003

Logo