Bose Companion 3 Series II Manual do Proprietário - Página 16

Procurar online ou descarregar pdf Manual do Proprietário para Altifalantes Bose Companion 3 Series II. Bose Companion 3 Series II 22 páginas. Multimedia speaker system
Também para Bose Companion 3 Series II: Manual do Proprietário (40 páginas), Manual do Proprietário (40 páginas), Manual do Proprietário (10 páginas), Manual do Proprietário (20 páginas), Manual do Proprietário (26 páginas), Manual de configuração rápida (2 páginas), Manual de configuração rápida (2 páginas), Instruções de montagem pormenorizadas (2 páginas), Manual de instalação (20 páginas), Especificações (6 páginas), Brochura e especificações (4 páginas), Manual do Proprietário (19 páginas), Manual de serviço (36 páginas), Manual de serviço (16 páginas)

Setting Up Your Lifestyle

Figure 13

RC-5 remote switch

settings

Connecting speakers to your Lifestyle

Figure 14

Speaker cable connections

on the ampliﬁer

Stereo Amplifier

Setting up the RC-5 remote control

If your system uses a Model 5 music center, you need to set up a second RC-5 remote control to operate

your Lifestyle

stereo ampliﬁer.

1. Remove the remote control battery cover and locate the miniature switches (Figure 13).

2. Make sure that the house code settings (switches 1, 2, 3, and 4) match those in your ﬁrst remote.

3. Slide switch 5 down (off) and 6 up (on).

Note: Refer to your Lifestyle

than one room.

CAUTION: DO NOT connect the ampliﬁer to powered speakers of any make or model, nor to any ampliﬁed

music sources. Doing so may cause damage to the equipment.

Speaker cable consists of two insulated wires. One wire is usually marked (striped, collared, or ribbed), indi-

cating that it should be connected to the positive (+ or red) terminal. The plain wire should always be con-

nected to the negative (– or black) terminal. For recommended wire sizes and lengths, see "Wire

recommendations" on page 18.

• Connect the right speaker cable to the SPEAKER OUTPUT R terminals (Figure 14). Press the red terminal

tab. Insert the wire coming from the speaker's positive (+) terminal into the red jack and release the tab.

Press the black terminal tab. Insert the wire coming from the speaker's negative (–) terminal into the black

jack and release the tab.

• Connect the left speaker cable to the SPEAKER OUTPUT L terminals in the same way.

Notice which speaker cable is connected to the L (left) output, and which is connected to the R (right) output

on the back of the ampliﬁer. Be sure that the speaker positioned on the left in the listening area (as you face

it) attaches to the cable connected to the L output.

January 4, 2002

system owner's guide for more information on operating your system in more

2 3 4

5 6 7 8

stereo ampliﬁer

AM262840_00_V.pdf