ABSCO SHEDS SIGNATURE ADCPSN3 Manual de instalação - Página 6
Procurar online ou descarregar pdf Manual de instalação para Armazenamento ao ar livre ABSCO SHEDS SIGNATURE ADCPSN3. ABSCO SHEDS SIGNATURE ADCPSN3 14 páginas. Carport
Imprimir páginaFITTING THE SHURELOCK BEAMS
0. Remove the protective plastic coating from
the outside of the beam.
CL
2. Make sure the ends of the beam are all the
way into the brackets and fasten each end with
four FAST100 tek screws.
These are visible screws so take time to position
them on the centreline of the BK3 bracket and
inset equally from the top and bottom.
3. Repeat these steps for the other long beam
SB2 before proceeding to step 4.
On the exterior side of the beam that will get the
gutter, only put in the lower teks for now.
Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE CARPORT
MODEL: ADCPSN3
3.11m W x 6.12m D x 2.60m H
1. Safely lift and place a longer SB2 beam inside
the taller post brackets BK3 as shown.
Overlap to
NOTE: Beam orientation is important to prevent
water entry.
Orientate the beam so the exterior face has the
overlap to the top.
4. Safely lift and place the first shorter beam SB1
inside the post brackets BK3 as shown.
5. Make sure the ends of the beam are as far
as they can go into the brackets, there will be a
small gap at the high-side due to angle.
Fasten each end with four FAST100 tek screws
as before.
6. Repeat these steps for the last SB1 beam
Model: ADCPSN3
top
Shorter posts
21/09/23
Overlap to
bottom
1.00
6