Atlas Copco D2160-Q Instruções do produto - Página 10
Procurar online ou descarregar pdf Instruções do produto para Perfurar Atlas Copco D2160-Q. Atlas Copco D2160-Q 20 páginas. Straight drill
Imprimir página
Service
Service
Maintenance instructions
Maintenance and service instructions
The service must only be done by authorized workshops or qualified service technicians.
WARNING Polymer hazard
The vanes in this product contain PTFE (a synthetic fluoropolymer). Due to wear, there might be
PTFE particles inside the product. Heated PTFE can produce fumes which may cause polymer fume
fever with flu-like symptoms, especially when smoking contaminated tobacco.
Health and Safety recommendations for PTFE must be followed when handling vanes and other com-
ponents:
Do not smoke when servicing this product
►
PTFE-particles must not come in contact with open fire, glow or heat
►
Motor components must be washed with cleaning fluid and not blown clear with an air line
►
Wash your hands before starting any other activity
►
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guidelines:
■
Clean appropriate parts accurately
■
Replace any defective or worn parts
Preventive maintenance
Make sure to perform a preventive maintenance every 6 months. If it is used in heavy duty conditions or
not running properly, it should be removed from operation for inspection more often.
Lubrication instructions
Rust protection and cleaning
Water in the compressed air can cause rust. To prevent rust we strongly recommend to install an air dryer.
Water and particles can cause sticking of vanes and valves. This can be prevented by installing an air fil-
ter close to the product to avoid pressure drop.
Before longer standstills always protect your tool by adding a few drops of oil into the air inlet. Run the tool
for 5–10 seconds and absorb any access oil at the air outlet in a cloth.
NOTICE Do not try to clear the air path using sharp tools.
The air inlet is equipped with a strainer. If this is punctured, foreign objects may harm the valves, resulting
in overspeed.
Lubrication guide
Brand
BP
Castrol
Esso
10
EN
© Atlas Copco Industrial Technique AB - 9839 1477 01
General purpose, Bearings and Gears
Energrease LS-EP2
OBEEn UF 1
Beacon EP2
D2160-Q