Bose Solo 10 series II Manual de serviço - Página 31
Procurar online ou descarregar pdf Manual de serviço para Altifalantes Bose Solo 10 series II. Bose Solo 10 series II 40 páginas. Tv sound system
Também para Bose Solo 10 series II: Manual de instruções de segurança importantes (20 páginas), Perguntas frequentes (3 páginas)
Imprimir página
1. PCB Cover Removal
1.1 Remove the 6 screws indicated in Figure 3.
1.2 Lift off the PCB Cover
2. Main PCB Removal
2.1 Perform procedure 1.
2.2 Remove the 5 screws indicated in Figure 4.
2.3 Disconnect the 2 cable connectors, and 1
ribbon cable from the Main PCB. Figure 5.
2.4 Lift up on the front of the PCB and then pull
it forward so the rear connectors clear the
enclosure openings.
Note: When replacing the Main PCB, ensure the
ground wire is secured as shown in Figure 5.
Also, ensure the speaker wire harness is located
in the channel shown in Figure 5.
3. Top Cover Removal
3.1 Perform procedure 1 and 2.
3.2 Remove the 31 screws indicated in Figure
6. 13 screws inside the PCB well and 18 screws
around the perimeter of the unit.
3.3 Flip the unit over and slowly lift off the top
cover. Use care to prevent the gasket from be-
ing pulled away with the top cover. The gasket
should remain in the channels of the enclosure.
Note: There is no replacement gasket available.
DISASSEMBLY PROCEDURES
Figure 3. PCB Cover Removal
Figure 4. PCB Removal
Ground wire
Figure 5. PCB Removal
Figure 6. Top Cover Removal
31
Speaker wire harness