Bose 131 Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Sistema de altifalantes Bose 131. Bose 131 18 páginas. Marine loudspeaker system
Também para Bose 131: Manual do Proprietário (37 páginas), Manual do Proprietário (23 páginas), Manual de serviço (7 páginas), Manual de serviço (7 páginas), Manual (7 páginas)

Select the locations for your speakers

Figure 2

Selecting the right locations

A. Mount from the rear if you

can insert the speaker enclo-

sure behind the bulkhead

mounting surface.

B. Mount from the front if you

cannot reach behind the

mounting surface. If you are

uncertain about the depth and

clearance behind your mount-

ing surface, consult your boat

manufacturer or dealer.

AM188201_02_V.pdf

In selecting locations for your speakers, understand that there are two possible mounting

options. It is easiest to mount the speakers from behind the mounting surface. However, if

you cannot reach behind the mounting surface, you may cut a larger hole that allows you to

insert the speaker enclosure from the front of the mounting surface. See Figure 2. With this in

mind, find a location that:

• Allows sufficient room to snap on the grille. Use the template to be sure there is

enough area around the holes you will cut in the bulkhead.

• Allows sufficient room for the speaker enclosure behind the bulkhead. During installation,

the enclosure requires 4

⁄

enclosure requires only 3

extension. The enclosure may be rotated in a complete circle, but attaches to the mounting

flange in only one position.

• Accommodates the speaker wire provided. Lay out lengths of wire that comfortably

reach from the receiver to each speaker. Be sure the wires are secure and protected

from being pinched, pulled, or damaged in any way.

• Is not close enough to adversely affect any compass.

Note: The magnets in the speakers will affect a boat compass. Avoid mounting the speakers

closer than three feet from the compass. If necessary, a marine installer can help correct any

deviation.

Note: Before going any further with your assembly, choose one of the methods de-

scribed in Figure 2 above. The instructions for A begin on page 7; B on page 11.

October 30, 2001

inches (11 cm) of mounting depth. However, once installed the

⁄

inches (9 cm) of mounting depth and 12 inches (31 cm) of

Setting Up