Bose 601 Series IV Direct/Reflecting Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de altifalantes Bose 601 Series IV Direct/Reflecting. Bose 601 Series IV Direct/Reflecting 11 páginas. Direct/reflecting speaker system
Também para Bose 601 Series IV Direct/Reflecting: Manual do Proprietário (11 páginas), Manual do Proprietário (13 páginas), Manual do Proprietário (11 páginas), Manual do Proprietário (18 páginas)
Imprimir página
Placing
the speakers
The product label on the back of each speaker indicates LEFT or RIGHT. For best acoustic
performance, place the left speaker on the left side as you face your speakers and place the
right speaker on the right side.
Keep the speakers 6 - 15 feet (1.8 - 6 m) apart and at least 10 inches (25 cm) from side walls
(see Figure 3).
It is important not to block the acoustic components
at the rear of each speaker. To avoid
this, place each speaker at least 8 inches (20 cm) from the wall behind it.
Figure 3
Idealspeaker placement
8" minimum (20 cm)
6-15ft
(1.8 - 6 m)
10" minimum
(25 cm)
Figure
4
Place each speaker at least
2 feet (.6 m) from your TV
screen.
Note: Bose ®601TM speakers are not intended to hang from wafts, or to stand on shelves or
tables. They are designed as floor-standing speakers only
,_
WARNING: To prevent personal injury, do not place your speakers in high-traffic areas where
they can be accidentally
knocked over.
Note: To prevent interference with your TV picture quality, 3lace each speaker at least 2 feet
(.6 m) from your TV screen.
2ft
I
II
2
.
minimum
II_
minimum L_
2
J
Choosing
the speaker
cord
It is important to use the proper gauge (thickness) of speaker cord. Standard zip cord (2-con-
ductor, 18-gauge or .82 mm 2wire or larger) is recommended
for most applications. You can
find this wire at most electrical and hardware stores.
If the length of speaker wire extends more than 20 feet (6 m) from a receiver or amplifier, refer
to "Wire recommendations"
on page 9 or contact your authorized Bose dealer for more infor-
mation.
Running
the speaker
cord
through
a wall
or under
a floor
Make sure you have enough cord to reach from the receiver to each speaker. For in-wall
installation, check your local building code requirements. Before proceeding, you may want
to contact an electrical installer for information
about your local building or safety regulations.
A M257731_ 00_ V.pdf
October 25, 2001
5