Bose ShowMatch DeltaQ SMAFT Manuais de instalação e segurança - Página 7

Procurar online ou descarregar pdf Manuais de instalação e segurança para Sistema de altifalantes Bose ShowMatch DeltaQ SMAFT. Bose ShowMatch DeltaQ SMAFT 13 páginas. Array rigging frames

Imprimir página

pro.Bose.com

Installation

Array Rigging

ShowMatch DeltaQ array loudspeakers are shipped with integrated link-bar rigging hardware. The

rigging system is designed to allow fast setup of typical concert-touring or fixed-installation arrays of up

to 24 full-range or 18 subwoofer modules while maintaining a 10:1 Safety Factor when used with Bose®

ShowMatch Array Frame Rigging Accessories.

Note: Always confirm safe working load limits with exact array configurations, pitch angles, and

connection points using either Bose Modeler® or Bose Array Tool software.

Note: Bose ShowMatch loudspeakers and rigging accessories are intended for installation by professional

installers only!

Note: All lifting operations require two individuals positioned on each side of the loudspeaker.

Refer to pro.Bose.com for additional product installation and setup information.

Connect Array Frame or T-Bar Array Frame to Full-Range Module

The ShowMatch Array Frame (SMAF) contains four connection points for subwoofer modules (all four

corners), and three connection points for full-range modules (two front corners and a center location).

Each side rail provides 21 rigging points, labeled according to the image printed on the frame. The center

rail provides seven rigging points, and is expandable to up to 45 points using the Multipoint Bracket

Accessory (SMAFMP). For more information about the Multipoint Bracket Accessory, see pro.Bose.com.

The ShowMatch T-Bar Array Frame (SMAFT) contains three rigging points for full-range array modules

(two front corners and rear center). The center rail provides seven rigging points, and is expandable to

up to 45 points using the Multipoint Bracket Accessory. The T-Bar Array Frame is compatible with full-

range modules (SM5, SM10, and SM20) only. Do not use the T-Bar Array Frame with subwoofer modules

(SMS118). To create an array with subwoofer modules, use the ShowMatch Array Frame.

The Array Frame and the T-Bar Array Frame each include two (2) shackle adapters to attach the frame to

chains or standard shackles, and four (4) Quick Pins to connect an array module to the frame. To create

a narrower array, remove the side end caps and tethered quick pins that are factory-installed on each

loudspeaker module, and use the optional Short Quick Pin Accessory Kit (SMQPS). For more information

about the Short Quick Pin Accessory Kit, see pro.Bose.com.

Installation Guide - ShowMatch

DeltaQ

Array Rigging Frames - 7