Bose SURROUND SPEAKERS 700 Manual - Página 3

Procurar online ou descarregar pdf Manual para Sistema de altifalantes Bose SURROUND SPEAKERS 700. Bose SURROUND SPEAKERS 700 29 páginas.

Imprimir página

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Bose Corporation could void the user's authority to operate

this equipment.

This device complies with part 15 of the FCC Rules and with ISED Canada license-exempt RSS standard(s). Operation

is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

This device complies with FCC and ISED Canada radiation exposure limits set forth for general population. This

equipment should be installed and operated with a minimum distance of 20 cm between radiator and your body. This

transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This device for operation in the band 5150 – 5250 MHz is only for indoor use to reduce the potential for harmful

interference to other co-channel systems.

CAN ICES-3(B)/NMB-3(B)

The product, in accordance with the Ecodesign Requirements for Energy Related Products Directive 2009/125/EC, is

in compliance with the following norm(s) or document(s): Regulation (EC) No. 1275/2008, as amended by Regulation

(EU) No. 801/2013.

Required Power State Information

Power consumption in specified power mode, at

230V/50Hz input

Time after which equipment is automatically

switched into mode

Power consumption in networked standby if all wired

network ports are connected and all wireless network

ports are activated, at 230V/50Hz input

Network port deactivation/activation procedures.

Deactivating all networks will enable standby mode.

For Europe:

Frequency bands of operation 2400 to 2483.5 MHz, 5150 to 5350 MHz, and 5470 to 5725 MHz.

Maximum transmit power less than 20 dBm EIRP.

Frequency band of operation 5725 to 5850 MHz.

Maximum transmit power less than 14 dBm (25mW) EIRP.

Maximum transmit power is below regulatory limits such that SAR testing is not necessary and exempt per

applicable regulations.

REG U LATORY I N FO R MAT IO N

Per Annex II 3(a) of Regulation 801/2013 ("Lot 26" amendment of

1275/2008), the requirement to deactivate a wireless port "does not

apply to products which rely on a single wireless network connection for

intended use and have no wired network connection."

Power Modes

Standby

≤ 0.5 W

≤ 2.5 hours

N/A

E N G

Networked Standby

Bose wireless ≤ 2.0 W

≤ 20 minutes

≤ 2.0 W