Advanced Radiant Systems COOL-SPACE CS6-36 Manual de operação e manutenção - Página 5

Procurar online ou descarregar pdf Manual de operação e manutenção para Ar condicionado Advanced Radiant Systems COOL-SPACE CS6-36. Advanced Radiant Systems COOL-SPACE CS6-36 16 páginas.

Imprimir página

4.0 Operating procedures

There are 3 factors to consider when determining where to place the COOL-SPACE

1. Fresh air supply: The inlet side of the unit (pad side) requires a constant,

uninterrupted supply of fresh air for maximum performance. A distance of 1

metre clear space to any obstructions at the rear or inlet side of the unit is

recommended.

2. Discharge air flow: The cool air discharged from the unit should be free of

obstruction to allow the air to circulate in order to maximize the cooling zone.

3. Ventilation: In order to operate at maximum effectiveness, it is helpful to have

provisions to remove the air discharged from the COOL-SPACE

cooling area. This ensures that the COOL-SPACE

that has already been through the evaporative cooling process.

The COOL-SPACE

create an oval shaped air pattern that can reach out as far as 21+ metres with larger fans.

Obstacles such as racks and workbenches may interfere with the air flow. An attempt

should be made to locate the unit in such a manner that interruption of the air pattern is held

to a minimum. Multiple units may be required to cover larger areas.

When the COOL-SPACE

recommended that there be a space of at least 1 metre between the back (pad side) of the

unit and the obstruction. This ensures that a clear supply of fresh air is able to get to the

inlet of the unit.

Operational weights:

CS16 Unit: 38 kg. (unit) + 10 kg. (pad operating weight) + 54 kg. (56 L. reservoir) = 103

kg.CS16 TB Unit: 52 kg. (unit) + 10 kg. (pad operating weight) + 189 kg. (200 L. reservoir) =

251 kg. CS36 Unit: 133 kg. (unit) + 27 kg. (pad operating weight) + 174 kg. (180 L.

reservoir) = 335 kg. CS48 Unit: 225 kg. (unit) + 45kg. (pad operating weight) + 232 kg. (240

L. reservoir) = 503 kg.

4.1 Filling the unit with water

Once the COOL-SPACE

turn the water supply valve on and the unit will fill with water. The float valve will shut off the

water flow when the sump is full.

4.2 Starting the fan

Turn the fan switch to HIGH speed on start-up, allow motor to reach maximum speed, and

then adjust to your preferred setting.

unit must be placed on a level surface to operate correctly. The units

unit is placed near a wall or other vertical obstruction, it is

unit has been connected to a water source as described in 3.1,

unit does not recirculate air

unit.

unit from the