Advanced Radio I Charger Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Carregador de bateria Advanced Radio I Charger. Advanced Radio I Charger 9 páginas.

Step 2

On each Charge port you will see a small slider switch. This slider

switch determines what battery chemistry and charge voltage is

applied to each charge port. You will see that the charger accom-

modates LiPo, Lion and LiFe.

Slider Switch

PLEASE NOTE:

BEFORE CONNECTING THE BATTERY OR 12volt POWER please set

the slider switch to match the battery chemistry. Failure to do

so could result in the battery pack receiving an incorrect charge

voltage and might damage the battery pack.

I Charge is designed to use with batteries that have an internal

battery balancing charge circuit.

If you are an advanced user then you know that some battery

chemistries do not require charge balancing however Advanced

Radio states that I Charger should be used only with self balanc-

ing batteries.

Step 3

On the opposite end of the charger you will notice that there are

three sets of plug in pins per port or board.

On the right you have the battery pins (BAT) , next is the F-Bus

pins and finally the TMP or temperature sensor pins. You can plug

your battery into the bat pins either way as the center is positive

and both outside pins are negative.

The F-Bus is for future developments.

The TMP port can be used with the optional temperature sensor.

These can be placed on the battery to warn of excessive tempera-

ture.

Battery

Connector

FBUS

Expander

Optional

Temperature

Sensor