Bose Acoustic Wave Music System Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Sistema estéreo Bose Acoustic Wave Music System. Bose Acoustic Wave Music System 20 páginas. Music system power pack
Também para Bose Acoustic Wave Music System: Manual do Proprietário (6 páginas), Manual do Proprietário (20 páginas), Manual do Proprietário (13 páginas), Manual do Proprietário (5 páginas), Manual do Proprietário (22 páginas)
Imprimir página
AWMDC_OG.book Page 5 Monday, May 5, 2003 11:03 AM
Selecting a location for your music system and changer
The Acoustic Wave
music system. Before you connect the two, however, select a good location for the stacked
units.
CAUTION: Setting up the two units separately (on different shelves of an entertainment cen-
ter, for example) is not recommended. Doing so will prevent proper communication between
the two and will adversely affect operation.
When choosing the location, remember that the tonal quality of your Acoustic Wave
system, as with any high-performance sound system, will vary with room placement.
Feel free to try different locations, but keep in mind that...
• The Acoustic Wave
counter, desk, or table top, 30 to 48 inches (75-120 cm) from the floor.
• The CD player in the Acoustic Wave
for the CD cover on top of the music system to open.
• The music system should be near the horizontal center of a wall and 6 inches (15 cm) or
less from the surface behind it.
• To increase the bass response, move the unit toward any corner of the room; to decrease
bass response, move it away from the corner.
Seating your Acoustic Wave
1. Place the multi-disc changer in the location you have chosen, following the guidelines
above.
2. Carefully seat your Acoustic Wave
sure that it sits flat and the side edges of both units are aligned (Figure 2b).
Note: The music system slips onto raised guides on top of the changer.
Figure 2
(a)
Seating the Acoustic Wave
®
music system (a) on top
of the multi-disc changer,
so (b) it sits flat and the two
units communicate
CAUTION: Maintaining a clear optical path between the multi-disc changer and the music
system, shown in Figure 2(b), is important. When the changer is turned on, it sends infrared
(IR) signals that also turn on the music system. If those signals are blocked, there may be no
sound when the changer is playing.
®
multi-disc changer is designed to fit right under your Acoustic Wave
®
music system is designed to sound best when placed on a shelf,
®
music system needs an allowance of several inches
®
music system on the multi-disc changer
®
music system on top of the changer (Figure 2a). Make
TM
(b)
IR signal
receivers
Raised
guides
Setting Up
®
®
music
IR signal
emitters
In alignment
5