Bose Personalized Amplification System Manual de resolução de problemas - Página 17
Procurar online ou descarregar pdf Manual de resolução de problemas para Sistema estéreo Bose Personalized Amplification System. Bose Personalized Amplification System 50 páginas.
Também para Bose Personalized Amplification System: Manual do Proprietário (28 páginas)
Imprimir página
1.3.2 Implementation
The power stands detects:
a) The number of bass modules B1 connected to "Amp3 out". This is done by measuring the
impedance between pins 2+ and 2- of the "Amp 3 out" connector. The B1 bass module has a
10k ohm resistor between those to pins.
b) The insertion of a 1/4" jack into the "Bass Line Out". A normalling connection of this jack is
connected directly to a flag pin on the DSP.
Depending on these detections, the PS1 will change system EQ and limiter settings. This infor-
mation is collected by the DSP and determines EQ and limiter settings through a lookup table:
Number
Impedance,
of Bass
Amp3
Modules
2+ - 2-
0
infinity
1
10k ohm
2
5k ohm
0
Infinity
1
10k ohm
2
5k ohm
??
0
Table 5. EQ lookup table for all operational modes
1.3.3 Debug Mode
Debug mode is entered when a resistance of 1k ohm or less is detected between pins 2- and 2+
at the "Amp3 Out" connector. In debug mode, all system EQ's are set to "flat" and the internal
limiters are bypassed. Most measurements should be done in debug mode.
A simple way to switch between the different modes is to create a "dummy" cable that brings out
pins 2- and 2+ to a banana plug. The modes can be switched by applying different numbers of
10k ohm resistors or a short between the leads of the banana plug. Pins 1+ and 1- of the
"dummy" cable can still be routed to a Speakon
THEORY OF OPERATION
Bass
Bass
Send
EQ
connected
No
0
No
1
No
2
Yes
3
Yes
4
Yes
5
Either
6
17
LA
Comment
EQ
0
No bass module:
L1: Select highpass at 110Hz
B1: 40-110Hz flat bandpass
1
L1: crossover at 180 Hz
B1: "nominal EQ" +6 dB
1
L1: crossover at 180 Hz
B1: "nominal EQ"
2
This mode is for use with external
powered sub.
L1: crossover at 180 Hz
B1: flat 40Hz to 180Hz
1
Undefined state, user may be using
rd
an external 3
single B1
L1: crossover at 180 Hz
B1: "nominal EQ"
1
This is the nominal case with an
additional external power stand
connected
L1: crossover at 180 Hz
B1: "nominal EQ" -6 dB
0
Debug Mode: all EQ and limiters
are by-passed.
®
connector to attach B1 bass modules.
party device with a