Bose Aviation Headset X Manual do Proprietário - Página 28
Procurar online ou descarregar pdf Manual do Proprietário para Auscultadores Bose Aviation Headset X. Bose Aviation Headset X 36 páginas. Owner's guide
Também para Bose Aviation Headset X: Manual do Proprietário (36 páginas), Manual de configuração rápida (1 páginas), Manual do Proprietário (36 páginas), Manual do Proprietário (16 páginas)
Imprimir página
Troubleshooting
In case of difficulty
Identify the problem in the left column of the table. Perform the corrective actions suggested in
the right column. If the problem persists, contact the Bose
using the contact information on page 33 of this guide, for assistance.
Problem
Communication but no active • Ensure that the headset is powered, and that the ON/OFF
noise reduction in either ear
Active noise reduction but no
communication or very low
volume communication in
both ears
Reduced active noise reduc-
tion, intermittent clicking
sounds, or communication
distortion in a loud environment
Reduced volume in one ear
only
Stereo missing or communi-
cations in one ear only
Squealing, whistling, or
chirping sound when the
system is turned on
28
What to do
switch is set to ON.
• If using aircraft power, check the aircraft fuse or circuit
breaker. The LED should be lit.
• If using battery power, ensure that the battery is fresh and
correctly installed.
• Check that the LED is lit. (A blinking green LED indicates
a good battery. A steady red LED indicates a low battery.)
• Check to see if the volume controls are set too low. (See
Volume Control for method of adjusting volume.)
• Check the volume setting of intercom/radio.
• Check the headset aircraft connection.
• Check the ports at the outside surface of each earcup to
ensure they are not blocked. If dust or dirt is present,
carefully remove the debris using tweezers. Do not
vacuum or blow out debris.
• Check to see if the volume control is set too low. (See
Volume Control for method of adjusting volume.)
• If using with a monaural aircraft audio system, verify
that the stereo/mono switch is set to mono.
• If plugged into a monaural system with the switch set to
stereo, you will hear only through the earcup to which
the cable is attached. Set the switch to mono.
• Check to see if the protective inner screen is damaged.
®
Aviation Headset Department,