Dromida DIDC0074 Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Carro de brincar motorizado Dromida DIDC0074. Dromida DIDC0074 4 páginas. Radio controlled brushless

Imprimir página

DRIVING THE VEHICLE

1. Switch radio on. (ALWAYS turn your radio

on fi rst!)

Brake/

Reverse

Forward

Neutral

• To slowly drive forward, pull the trigger slightly. To drive faster,

pull the trigger further.

• To brake, push the trigger. To drive in reverse, push again.

• During a crash, release the trigger.

• When the vehicle battery becomes low, the vehicle will start to slow down.

• Allow the battery to cool before recharging.

• Make sure to turn both the vehicle and the radio off after each use.

• ALWAYS unplug the battery after each use.

TRIMS AND DUAL RATES

Throttle Dual Rate (Speed Limiter)

• NOTE: We recommend limiting the vehicle's maximum speed for beginners and gradually

increasing the top speed once you become more comfortable with the controls.

• If you need to limit the maximum speed of your vehicle, rotate the "TH.D/R" knob

counterclockwise. For higher top speeds, rotate the knob clockwise.

Steering Dual Rate

• If you need to limit the amount of steering your vehicle has, rotate the "ST.D/R" knob

counterclockwise. For more steering, rotate the knob clockwise.

2. Install the battery into the vehicle and

connect the battery.

3. Secure battery strap to post using clips.

Forward

Reverse

• To turn, rotate the wheel to the left or right.

• Adjust the steering trim if the car doesn't track straight (see

Throttle Trim

• If the vehicle rolls forward without throttle input, rotate the throttle trim knob slightly left.

• If the vehicle rolls backwards without throttle input, rotate the throttle trim knob slightly right.

Steering Trim

• If the vehicle tracks right (when viewed from behind),

rotate the steering trim knob slightly left.

• If the vehicle tracks left (when viewed from behind),

rotate the steering trim knob slightly right.

• Check that the servo saver screw is fully tightened to

ensure that your vehicle tracks straight.

4. Switch vehicle on.

Left

Right

Left

below).

Right