Dromida KODO FPV Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Drones Dromida KODO FPV. Dromida KODO FPV 8 páginas.

Imprimir página

Step 3

● Set up a course.

Keep it simple at first. When you can fly while maintaining your altitude, set up a

course with gates or obstacles at different heights.

The goals are to fly the entire course while maintaining the altitude and increase

your speed around the course.

BLADE GUARD REPLACEMENT

BLADE REPLACEMENT

NOTE: Rotor blades must be installed as shown.

•

Carefully pry off the

blade using a fl at head

screwdriver.

•

Rotor blades are marked

with an A or B.

•

Yellow rotor blades are

front and black are rear.

•

Match the A and B

blades to this drawing

to ensure that the

replacement blades are

in the correct locations.

SENSOR CALIBRATION

It is normal for the KODO FPV to

require minor corrections while

hovering. If the quad has a strong

tendency to drift in one direction, the

sensors may need calibration.

1. Power up and link the controller

and the KODO FPV.

2. Place the quad on a level surface.

3. Hold both sticks in the lower right

corners. When the LED on the quad

starts to fl ash rapidly, release the

sticks but do not move the KODO

FPV until the LED is steady again.

1. Carefully pry off the blade using a flat

head screwdriver. NOTE: Do one corner

at a time so you don't accidentally mix

up the blades.

2. Pull the blade

guard up and off

the motor housing.

Install the new

guard and replace

the rotor blade.

MOTOR REPLACEMENT

1. Remove the rotor blade from the motor.

2. Remove the blade guard from the motor housing.

3. While holding the motor locking tab open, place the motor shaft on a solid surface

and push down on the arm to force the motor up and out of the motor housing.

4. Remove the wires from the brackets on the arms and unplug the assembly from

the control board.

5. Before installing the new motor, make sure that the wires are the same color and

are installed in the same positions in the connector.

TROUBLESHOOTING

PROBLEM: KODO will not stay level or drifts while hovering.

SOLUTION: (1) Calibrate the sensors – see the Sensor Calibration section.

(2) Check the rotor blades and motors for damage. A common

problem is lint wrapped around the motor shaft.

PROBLEM: Red controller LED light flashes after linking.

SOLUTION: Replace with new AAA batteries.

PROBLEM: The KODO FPV will not respond to the controller.

SOLUTION: (1) Relink the controller and the KODO FPV.

(2) Make sure the flight battery is fully charged.

PROBLEM: Unable to flip but the KODO flies.

SOLUTION: Battery voltage is low and needs to be charged.

PROBLEM: Will not take off.

SOLUTION: (1) Check the rotor blades for proper installation.

(2) Battery is not fully charged.

(3) Check motors and props for damage.

PROBLEM: Drone is shaking.

SOLUTION: Check the canopy, chassis, motors and rotor blades for damage.

SAFETY PRECAUTIONS

Follow these safety precautions when operating this or any model drone.

•

Adult supervision required.

•

Do not touch the spinning blades or fly over people or animals.

•

Keep your face and body as well as all spectators away from the rotors

whenever the battery is connected.

•

Stay clear of buildings, trees and power lines. AVOID flying in or near crowded

areas. DO NOT fly close to people, children or pets.

•

Maintain a safe pilot-to-drone distance while flying.

•

Your KODO drone should not be considered a toy, but rather a small, working