Dromida Ocular Manual de voo de arranque rápido - Página 3

Procurar online ou descarregar pdf Manual de voo de arranque rápido para Drones Dromida Ocular. Dromida Ocular 13 páginas.

Imprimir página

LITHIUM BATTERY WARNING

WARNING: This product includes a lithium polymer (LiPo) battery.

Improper handling could result in FIRE! A lithium battery fire has the

potential to ignite surrounding areas and may cause property damage or cause

personal injury.

For safe LiPo handling, follow all of these guidelines:

• ALWAYS keep out of reach of children!

• NEVER charge a LiPo battery on a flammable surface or near combustible materials.

• NEVER charge inside a vehicle or at a location that could be damaged in the

event of a LiPo fire.

• NEVER charge or use a battery that is deformed, bent, crushed or has any

type of visible damage.

• ALWAYS use the included, factory-approved charger with this LiPo battery.

• ALWAYS keep a supply of sand accessible when charging. Dumping sand on

the battery will assist in extinguishing a LiPo chemical fire.

• MOST IMPORTANT! NEVER leave the charger and LiPo battery unattended

while charging.

• It is normal for the charger to become warm to the touch. However,

disconnect the battery and unplug the charger immediately if either

becomes hot, begins to swell, or smoke!

• ALWAYS disconnect the battery and unplug the charger if the charge time

exceeds 3 hours.

• ALWAYS disconnect the battery and unplug the charger after the charge is

complete.

• ALWAYS disconnect and remove the battery from your model immediately

following operation.

• ALWAYS store/transport LiPo batteries in a fireproof container away from

combustible materials.

• NEVER put a LiPo battery in the pocket of any clothing.

• Keep LiPo batteries out of reach of animals. A punctured battery

may cause a fire.

• NEVER use the included charger for any other battery other than the one

included with this model.

• In the event of a crash, ALWAYS place the battery into a fireproof container

immediately. Examine the battery for damage before further use.

• ALWAYS operate and store batteries between 40-110° F (4-43° C).

• NEVER allow the battery temperature to exceed 140° F [60° C] during

operation.

• NEVER disassemble or modify a battery, its wiring, or puncture cells, as this

may result in fire.

• NEVER allow the battery to short circuit by touching exposed wires together.

• ALWAYS stop the operation of your model immediately when the battery

power is low. A battery failure can occur when attempting to recharge an

over-discharged battery.

LiPo batteries must always be recycled or disposed of properly.

If you are unable to follow these guidelines, return this product to the place of purchase.

CONTROLLER

Video

Headless Mode

Phone Holder

Button

On/Off Switch

Throttle/Rudder

Rudder

ON/OFF Aileron

Stick

Trim

Remove the screw on the battery compartment cover. Take the cover off and insert

(4) AAA batteries. Replace cover, securing with the screw.

• Do not mix old and new batteries.

• Do not mix alkaline, standard, or rechargeable batteries.

CAUTION: Risk of explosion if battery is replaced by an incorrect type.

Dispose of used battery according to the instructions.

CHARGING the FLIGHT BATTERY

Plug the charger into a USB port or AC adapter

(DIDP1125, not included) and connect the battery.

The red LED will flash slowly while the battery is

charging. The LED will be steady when the battery

is fully charged.

• NEVER leave the battery unattended while charging.

• DO NOT allow the USB port to power down while

the charger is connected to the battery.

• ALWAYS unplug the charger from the USB

port and the battery when charging is

complete.

• The battery connector will only fit in one way.

GET READY TO FLY

1. Charge the fl ight battery.

2. Turn on the controller.

3. Connect the fl ight battery to the Ocular and set it on a

level surface. The controller will beep and the LEDs on

the drone's arm will fl ash rapidly.

4. For your fi rst fl ight, we recommend calibrating

the sensors (page 3).

5. Move the throttle stick to its highest position

and listen for a beep.

6. Move the throttle stick down to its lowest

position and listen for a beep. The fl ashing LEDs

on the Ocular's arms will become steady.

The Ocular's motors are now armed and can be started with the start/stop button.

Elevator

Picture

Trim

Button

Aileron/Elevator

Trim

Stick