Elegoo MARS 4 Series Manual do utilizador - Página 15
Procurar online ou descarregar pdf Manual do utilizador para Impressoras 3D Elegoo MARS 4 Series. Elegoo MARS 4 Series 20 páginas.
Também para Elegoo MARS 4 Series: Manual do utilizador (20 páginas)
Imprimir página
Software Installation and Setup
Bottom Wait After Lift:
When printing the bottom layer, the time difference between the build
platform starting stationary and starting to return to the printing surface after lifting, the default
setting is 0 seconds.
Bottom Wait Before Cure:
When printing the bottom layer, after the build platform moves to the
printing surface, the time difference between the build platform starting stationary and the start
of exposure, the default setting is 0.5 seconds.
Bottom Wait After Cure:
When printing the bottom layer, the time difference between the end of
the print exposure and the start of the build platform to leave the printing surface, the default
setting is 0 seconds.
Bottom Lift Distance:
During the bottom printing process, the distance that the build platform
leaves the printing surface each time, the default setting is 2+3mm.
Lifting Distance:
In the normal layer printing process, the distance that the build platform leaves
the printing surface each time, the default setting is 2+3mm.
Bottom Retract Distance:
During the bottom printing process, the retract distance of the build
platform, do not change if not necessary.
Retract Distance:
In the normal layer printing process, the retract distance of the build platform,
do not change if not necessary.
Bottom Lift Speed:
During the bottom printing process, the moving speed of the build platform
away from the printing surface each time, the default setting is 75+230mm/min.
Lifting Speed:
In the normal layer printing process, the moving speed of the build platform away
from the printing surface each time; the default setting is 75+230mm/min.
Bottom Retract Speed:
During the bottom printing process, the moving speed of the build platform
is close to the printing surface; the default setting is 230+75mm/min.
Retract Speed:
In the normal layer printing, the moving speed of the build platform is close to the
printing surface; the default setting is 230+75mm/min.
Parameter Mode:
The default static mode allows the printer to print according to the parameters
set in the slicing software, or you can choose the high-speed mode or smooth mode, the printer
will dynamically adjust the printing parameters according to the complexity of the model to
improve the printing quality and printing speed.