DROPLUX HX-DLV004-RFBK Introdução ao produto - Página 5
Procurar online ou descarregar pdf Introdução ao produto para Controlador DROPLUX HX-DLV004-RFBK. DROPLUX HX-DLV004-RFBK 7 páginas. 2.4g wireless-sync-control rgbcw led controller
Imprimir página
No
Patterns
White breathe
1
3 color jumpy
2
7 color jumpy
3
3 color fade
4
Typical Applications
About RF code.
The biggest advantage of this system is that it can not only solve the cabling problem in engineering
wirelessly, but also realize a wired-like operation experience. In order to facilitate the early testing and
debugging of the project, the factory status of the receiver is normally unpaired and each remote controller
has a unique code value. The user should perform the matching work of the remote controller and the
receiver during the installation of the project to avoid the mutual influence of the radio frequency remote
control technology during the later use.
Please pay attention to the following 3 points before operation:
1) All equipment in the complete system after installation should have a unified and unique code value,
so as to achieve the security and stability of the system.
2) The receiver can only store one code value and cannot be overwritten. Before learning the new code
value, it is necessary to clear the original code of the receiver; the remote controller can only save one
code value but can be overwritten and can also restore the factory settings. In order to facilitate the later
maintenance, the three components that may be involved in the system (including receivers, handheld
remote controllers, and panel remote controllers) can realize mutual learning of code values.
3) The clearing operation should be finished within 1 minutes after the receiver is powered on.
Therefore, during the clearing operation, ensure that the lights in other areas are turned off or the power-on
time exceeds 1 minute to avoid other areas being cleared.
4) Since the receiver performs code value learning in the power-on state, in order to avoid confusion in
the area, it is recommended that each area has an independent power switch so that the power of other
areas can be easily cut off when the code is being operated.
（1）Code pairing operation: means that the receiver will only be controlled by the value code
remote controller.
Step
Connecting the load to the receiver and power
1
on it.
2
Select area
Remarks
No
5
Speed is adjustable,
6
brightness is
7
unadjustable
8
Operation
Patterns
Remarks
7 color fade
R/G cross fade
Speed is adjustable,
brightness is unadjustable
R/B cross fade
G/B cross fade
Instructions
1.It is necessary to clear the code first, if the
receiver was coded before.
2.Batch operation can be performed within the
remote control range.
Select the area with the "Zone" key and the
5 / 7