DROPSA GRIP Manual do utilizador e de manutenção - Página 2

Procurar online ou descarregar pdf Manual do utilizador e de manutenção para Sistemas de lubrificação DROPSA GRIP. DROPSA GRIP 9 páginas.

Imprimir página

1. INTRODUCTION

This user's and maintenance manual refers to GRIP air/oil lubrication system.

This manual should be conserved in such a way that it remains undamaged over time and is readily available to personnel

needing to consult it.

Further copies of this manual, updates or clarifications can be obtained by directly contacting the Technical Sales Office at

Dropsa.

The manufacturer reserves the right to update the product and/or the user's and maintenance manual without the

obligation to revise previous versions. It is however, possible to contact the Technical Sales Office for the latest revision in

use, or to consult our web site at http://www.dropsa.com.

The use of the equipment referred to in this manual must be entrusted to qualified personnel with a basic knowledge of

mechanics, hydraulics and electrical systems.

It is the responsibility of the installer to use tubing suitable for the system; the use of inadequate tubing can cause

problems with the pump, injury to persons and create pollution.

Loosening of connections can cause serious safety problems; carry out a check before and after installation and, if

necessary retighten them.

Never exceed the maximum working pressure values permitted for the panel and the components connected to it.

Before any maintenance or cleaning operation disconnect the power supply, close off the air supply and discharge the

pressure from inside the equipment and the tubing connected to it.

Do not subject the panel, the connections, the tubing or parts under pressure to violent impacts; damaged tubing or

connections are dangerous and should be immediately replaced.

After long periods of inactivity check air tightness of all parts subjected to pressure.

Personnel must use personal protection equipment, clothing and tools adequate for the location and the use of the panel

both during its operation and during maintenance operations.

The panel, and any accessories mounted on it, should be carefully checked immediately on receipt and in the event of any

discrepancy or complaint the Dropsa SpA Sales department should be contacted without delay.

Dropsa SpA declines to accept any responsibility for injuries to persons or damage to property in the event of the non-

observance of the information presented in this manual.

Any modification to component parts of the system or the different destination of use of this system or its parts without

prior written authorization from Dropsa SpA will absolve the latter from any responsibility for injury to persons and/or

damage to property and will release them from all obligations arising from the guarantee

2. GENERAL DESCRIPTION

The GRIP pump is to be utilized for tools with dry machining components, dry working on milling, drilling, tapping and

sawing machines, plastic, woodworking machines, chain lubrication, presstool applications with the ability to apply the

pump quickly to machine tools without the need for drilling. For the installation no drilling is required thanks to the

magnet, which ensures rapid and secure application of the pump.

Grip is the ideal solution for small machines, optimisation workshop lubrication pro cesses, flexible regulation of

the amount of oil at each point (0 to 30 mm

3. IDENTIFICATION OF THE MACHINE

A yellow plate showing the product code and the basic characteristics is mounted on the front of the oil tank.

4.TECHNICAL SPECIFICATIONS

CHARACTERISTIC

Air supply pressure

Working temperature

Working humidity

Permitted lubricants

Oil viscosity at working

temperature

Conservation temperature

WARNING: DO NOT supply the machine with voltages or pressures other

than those indicated on the specification plate

per cycle), and it increases tool life.

GRIP lubrication panel

6 bar (58,8 ÷ 88,2 psi)

-5 °C

+55 °C (+23 °F

Mineral - synthetic

15 - 320 cSt (150 ÷ 1480

-20 °C

+65 °C (-4 °F

131

)

÷ +

°F

90% max

)

SUS

149 °F)