DROPSA VIP4Air Series Manual do utilizador e de manutenção - Página 2
Procurar online ou descarregar pdf Manual do utilizador e de manutenção para Sistemas de lubrificação DROPSA VIP4Air Series. DROPSA VIP4Air Series 13 páginas. Minimal air/oil lubrication system
Também para DROPSA VIP4Air Series: Manual do utilizador e de manutenção (16 páginas)
Imprimir página1. INTRODUCTION
This user and maintenance manual refers to the VIP4Air air/oil lubrication system.
This manual should be conserved in such a way that it remains undamaged over time and is readily available to personnel
needing to consult it.
Further copies of this manual, updates or clarifications can be obtained by directly contacting the Technical Sales Office at
Dropsa.
The manufacturer reserves the right to update the product and/or the user and maintenance manual without the obligation to
revise previous versions. It is however, possible to contact the Technical Sales Office for the latest revision in use, or to consult
our web site at http://www.dropsa.com.
The use of the equipment referred to in this manual must be entrusted to qualified personnel with a basic knowledge of
mechanics, hydraulics and electrical systems.
It is the responsibility of the installer to use tubing suitable for the system; the use of inadequate tubing can cause problems
with the pump, injury to persons and create pollution.
Loosening of connections can cause serious safety problems; carry out a check before and after installation and, if necessary
retighten them.
Never exceed the maximum working pressure values permitted for the panel and the components connected to it.
Before any maintenance or cleaning operation disconnect the power supply, close off the air supply and discharge the pressure
from inside the equipment and the tubing connected to it.
Do not subject the panel, the connections, the tubing or parts under pressure to violent impacts; damaged tubing or
connections are dangerous and should be immediately replaced.
After long periods of inactivity check air tightness of all parts subjected to pressure.
Personnel must use personal protection equipment, clothing and tools adequate for the location and the use of the panel both
during its operation and during maintenance operations.
The panel, and any accessories mounted on it, should be carefully checked immediately on receipt and in the event of any
discrepancy or complaint the Dropsa SpA Sales department should be contacted without delay.
Dropsa SpA declines to accept any responsibility for injuries to persons or damage to property in the event of the non-
observance of the information presented in this manual.
Any modification to component parts of the system or the different destination of use of this system or its parts without prior
written authorization from Dropsa SpA will absolve the latter from any responsibility for injury to persons and/or damage to
property and will release them from all obligations arising from the guarantee.
2. GENERAL DESCRIPTION
The VIP4Air panel is to be utilized for 'on mandrel' applications and machine tools.
Designed for high performance at a low cost, it is distinguished by its compactness.
The system is composed of a central unit which controls and manages the entire system.
The central unit regulates and controls the functioning of the modular doses and mixers, which are composed of pneumatically
controlled mini-pumps and the mixer bases. The mini-pumps can be fitted with a series of spacers in order to vary the flow rate
so as to cover a wide range of needs. Integrated inside the mixer base is a flow control, which is utilized by the central unit to
verify the correct functioning of the equipment.
The modular design of the system makes it extremely versatile; up to a maximum of 8 mixer bases can be installed.
The high technology utilized in this system permits a total control of the lubrication combined with a simplicity of installation
without resorting to superfluous connections.
3. IDENTIFICATION OF THE MACHINE
A yellow plate showing the product code, the supply voltage and the basic characteristics is mounted on the front of the oil tank.
2