DROPSA 0086450 Manual do utilizador e de manutenção - Página 4

Procurar online ou descarregar pdf Manual do utilizador e de manutenção para Inversor DROPSA 0086450. DROPSA 0086450 8 páginas. Hydraulic inverter

5. COMPONENTS

Pump

Return

6. UNPACKING AND INSTALLATION

6.1 UNPACKING

Once a suitable installation position has been identified, unpack the product and prepare for installation. It is important to

inspect the product to ensure that there has been no damage during transportation. The packaging material used does not

require any special disposal procedures. You should refer to you regional requirements.

6.2 Installing

Fixing the valve on the pump using four M10 screws supplied, tightening with a torque of 35 Nm. Pay attention at the

correct positioning of ORings.

Connect two outlet pipes to G3 /8" holes marked 1 and 2 on the adapter plate.

7.1 Start-up

Before using the product, a few preliminary checks must be performed:

 Check Modular directional valve integrity;

 Check that the valve is at running temperature and

that the pipes are free of air pockets



Check that the electrical connection has been carried

out correctly;

 Check that there aren't lubricant leakage or air

pressure loss;

 Check that the lock screws are properly screwed up;

Line 2

Line 1

35Nm

 Use gloves and safety goggles, as stipulated in the

safety chart for the lubricating oil;

 DO NOT use lubricants that may irritate the NBR

gaskets; if in doubt, contact the Dropsa SpA technical

office, which can provide you with a detailed chart of

recommended oils;

 Not ignore dangers to the health and maintain the

regular hygiene standard.

VALVE COMPONENTS

Adapter plate for SUMO/MINISUMO

Pressure adjustment