anko LD-T7051 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Torradeira anko LD-T7051. anko LD-T7051 8 páginas.

FOR THE FIRST USE

Due to residue or oil remained in the heating element from manufacture, the

toaster may emit an odour when used for the time. This is normal and will subside

after some time. For the first use, it is suggested to operate the toaster according to

below steps described under the heading 'Toasting', except without bread, then let

the toaster cool down and begin toasting the first slice.

CAUTION: The bread may burn; therefore, toaster must not be used near or

below curtains and other combustible materials. The toaster should be

attended when in use.

Important: Never let the toaster operate unattended.

Important: Do not operate the toaster without the crumb tray.

Toasting

1. Unwind the power cable to the required length and plug it in.

2. Use the touch button "Setting" to adjust the toasting level you desire.

3. Place the food to be toasted in the toast slot.

4. Press the Push-down lever down until it engages. The LED on the Cancel

button will light up.

5. Toasting ends when the food being toasted is raised up. The LED on the Cancel

button goes out.

Note: The toasting can be interrupted at any time by pressing the Cancel button.

Never lift the Push-down lever to cancel toasting.

Tip: If you toast only one slice, set the toasting level lower than for two slices.

Reheating cold bread or toast

1. Insert the cold bread to be toasted

2. Press the push-down lever down until it engages. The LED on the Cancel button

will light up.

3. Then press the "Reheat" button.

Toasting frozen bread

1. Set the desired browning level with the 'SETTING' button.

2. Insert the frozen bread to be toasted.

3. Press the push-down lever down until it engages. The LED on the Cancel

button will light up.

4. Press the "Defrost" button. The LED on the Defrost button will light up.