ANLIDAR MYTORQ MY9-0206L Manual de operação e manutenção - Página 7

Procurar online ou descarregar pdf Manual de operação e manutenção para Chave de fendas eléctrica ANLIDAR MYTORQ MY9-0206L. ANLIDAR MYTORQ MY9-0206L 11 páginas.

Imprimir página

● Do not drop or abuse the tool.

● Whenever a tool is not being used, position the Power Switch to the "OFF" position and unplug the power cord.

Attaching / detaching bit and bit type

Push up the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely attached and detached (single finger

notion type) select such a bit whose shank is equal to the size shown below.

 Insert the power plug into a receptacle and set the changeover switch to "F" position.

 Apply the bit to the screw head and press the lever or push main body to, then the switch will be turned ON to start the motor

running.

 When the screw is tighten and reach the torque that you had set, The tool will stopped automatically.

 To reset the tool by releasing the lever to the original position or releasing the bit From the screw head.

 To return the screw, set the changeover switch to "R" position.

Hi/Lo Switch

When the TR0206 Series rotating speed needs to be changed, set up the switch to Hi for the fastest rotation, and set

up the switch to Lo for slowest rotation. It's possible that the uncompleted shut-off occurs when the switch is setup to Lo and the

presetting torque is more than 50% of torque range. Please refer to the following table.

MY9-

Lo Switch

0206L

3( N.m )↓

3( N.m )↑

CAUTION

Description of Operation

MY9-

0309L

0612L

4.5( N.m )↓

6( N.m )↓

4.5( N.m )↑

6( N.m )↑

MY9-

0206LF

0206P

3( N.m )↓

3( N.m )↑

MY9-

0309P

0612P

4.5( N.m )↓

6( N.m )↓

4.5( N.m )↑

6( N.m )↑

MY9-

0206PF

3( N.m )↓

3( N.m )↑