Anolis ArcPower 36 Manual do utilizador - Página 15

Procurar online ou descarregar pdf Manual do utilizador para Equipamento de iluminação Anolis ArcPower 36. Anolis ArcPower 36 19 páginas.

Imprimir página

9.Control of the ArcPower 36 via RS-232

9.1Wiring an RS-232 serial port

9-pin D connector (male)
Front view of the socket:
RS-232 cable:
9-pin D connector- female
ArcPower driver
Pin 1:
Pin 2: Received Data
Pin 3: Transmited data
Pin 4:
Pin 5: Signal ground
Pin 6:
Pin 7:
Pin 8:
Pin 9:
The maximum cable length according to the standard is 15 metres or the cable length equals to a capacitance
of 2500 pF.

9.2 Selecting a zone

The number of the zone distinguishes individual drivers which are controled via RS-232 interface.
Select SPE in main menu of the ArPower 36 ,press [ENTER],use [UP] and [DOWN] buttons to select Zon.
The option enables to select desired number of the zone (from 0 to 9).Press [ENTER],use [UP] and [DOWN]
buttons to select zone number and press [ENTER] to confirm selection.

9.3 Setting a serial port of PC

The serial port of your personal computer hould be configured as follows:
9600 Baud,8 Data Bits,Non Parity,One Stop Bit,No Flow Control Required.

9.4 Zone commands

The ArcPower 36 uses the 3 types of the zone commands which can be used in a suitable software running
on PC.
All zone commands stated below have to be send to the ArcPower 36 in ASCII codes.
Type 1: Selection of the preset colours
The syntax of the command is:
zone Z red;
zone Z green;
Pin 1: Not connected
Pin 2: Received Data
Pin 3: Transmitted Data
Pin 4:
Pin 5: Signal Ground
Pin 6:
Pin 7:
Pin 8:
Pin 9: Not connected
9-pin D connector - female
15
PC
Pin 1:
Pin 2: Received Data
Pin 3: Transmited data
Pin 4:
Pin 5: Signal ground
Pin 6:
Pin 7:
Pin 8:
Pin 9: