Daikin R32 Split Series Manual de instalação - Página 11

Procurar online ou descarregar pdf Manual de instalação para Ventilador Daikin R32 Split Series. Daikin R32 Split Series 14 páginas. R32 split series
Também para Daikin R32 Split Series: Manual de instalação (17 páginas), Manual de instalação (16 páginas), Manual de instalação (16 páginas), Manual de instalação (16 páginas), Manual de instalação (17 páginas), Manual de instalação (16 páginas), Manual de instalação (20 páginas), Manual de instalação (14 páginas), Manual de instalação (14 páginas), Manual de operação (16 páginas), Manual de operação (16 páginas), Manual de operação (8 páginas), Manual de instalação (17 páginas), Manual de instalação (16 páginas), Manual de instalação (20 páginas), Manual de instalação (20 páginas), Manual de instalação (16 páginas), Manual de instalação (16 páginas), Manual de instalação (14 páginas), Manual de instalação (16 páginas), Manual de instalação (17 páginas), Manual de instalação (20 páginas), Manual de instalação (13 páginas)

[Method of mounting conduit]

1) Dismount the service lid by removing the 2 screws.

2) Pass wires through the conduit and secure them with a lock nut.

3) After completing the work, reattach the service lid to its original position.

Terminal block

For power supply

Shape wires so that the

service lid fits securely.

Lock nut

Ground

This air conditioner must be grounded. For grounding, follow all local, and state electrical codes.

Facility Setting

(cooling at low outdoor temperature)

WARNING

• Make sure to turn the power OFF before removing the service lid.

CAUTION

• If the outdoor unit is installed where the heat exchanger of the unit is exposed to direct wind, provide a windbreak wall.

• Intermittent noises may be produced by the indoor unit due to the outdoor fan turning on and off when using facility settings.

• Do not place humidifiers or other items which might raise the humidity in rooms where facility settings are being used.

A humidifier might cause dew condensation from the indoor unit outlet vent.

• Activating the facility setting sets the indoor fan tap to the highest position.

Notify the user about this.

This function is designed for facilities such as equipment or computer rooms. It is never to be used in a

residence or office where people occupy the space.

1) Turning on SW5-3 on the PCB will extend the operation range to 14°F (–10°C).

Installing an air direction adjustment grille (sold separately) will further extend the operation range to –4°F (–20°C). In these

cases, the unit will stop operating if the outdoor temperature falls below –4°F (–20°C), restarting once the temperature rises

above this level.

■

English

Conduit

mounting

plate

Conduit

Remove

the switch

Screw

cover

Service lid

Screws

PCB

Turn on

switch 3

OFF

SW5