247Security Zeus-L Manual rápido - Página 4

Procurar online ou descarregar pdf Manual rápido para DVR 247Security Zeus-L. 247Security Zeus-L 13 páginas.

Imprimir página

CAMERA CABLES

Camera Cables (available in lengths of 15, 35 or 50 feet) use the STP (shielded twisted pair) cable standard. The

camera cables are connected using molded 2x3 Molex interfaces that are keyed to prevent improper mating. Each

connector uses a clip to snap securely to each camera and to the inputs on your DVR. Typical configurations are

such that the passenger cameras connect to inputs 1 and 2; and, if available, door, exterior, or driver cameras

connect to inputs 3 and 4. After the installation, all Camera Cables should be concealed and holes filled with

grommets to protect the equipment from vandalism.

EVENT MARKER

The Event Marker is used for the driver to indicate a critical event during recording, which the DVR will interpret as a

priority video for later review. When the driver presses the event marker button, the DVR will mark all video feeds

from 150 seconds prior to and after the button press. These priority event videos can be retrieved by the technician,

using our USB memory stick, to be viewed on a computer with the DVRViewer application installed, removing the

storage media and bringing inside for review or in conjunction with our Touchdown WIFI system for automatic

upload of the video event. The Event Marker module has one button, to signal an event, and 3 color lights to indicate

three DVR states: green for POWER; amber for RECORDING; and red for VIDEO LOST when a camera signal has

been lost.

POWER CABLE

A three-wire, 12-feet-long Power Cable is used for connecting the DVR directly to the battery power in the vehicle's

electrical box. The cable uses a large molded 2x2 Molex connector that is keyed, thereby connecting to the DVR in

only one orientation. The cable's three wires are described in the following table:

POWER CABLE

DC IN (Red)

GND (Black)

IGN. ON/OFF (White)

Two screws (#4 thread, 3/8" long) are included to securely fasten the Power Cable to the DVR. Securing the Power

Cable to the DVR prevents occupants from deactivating the system by disconnecting the Power Cable

MAKE SURE TO FUSE BOTH THE RED AND WHITE POWER LINES WITH A 7.5A FUSE (NOT

INCLUDED)

SENSOR & ALARM CABLE (DIGITAL I/O)

The Digital I/O Cable is used for connecting the DVR to the vehicle's pertinent electrical functions, such as the turn

signals, brake lights, and the stop-arm. The cable is 15 feet long and connects to the DVR using a molded 2x5 Molex

connector, and to the vehicle's equipment using 4 twisted pairs of wires. Using the Digital I/O Cable is an optional

function at your discretion.

247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com

Constant LIVE Power Source (battery side of solenoid, direct current)

Ignition-switched Power (live only if ignition is turned to ON/ ACC)

Digital Input #

Wire Color

DI 1

Brown

DI 2

Green+White

DI 3

Green

DI 4

Orange+White

DI 5

Orange

USERS MANUAL

ZEUS mDVR

BUS ELECTRICAL PANEL

Ground in bus electrical panel

Function

TEXT OVERLAY – AMBER

TEXT OVERLAY – STOP-ARM

TEXT OVERLAY – BRAKES

TEXT OVERLAY – LEFT SIGNAL

TEXT OVERLAY – RIGHT SIGNAL

. NOTE: