Anova TPB3003 Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Equipamento para relva e jardim Anova TPB3003. Anova TPB3003 11 páginas. Battery pruning scissors
Imprimir página3. Use and maintenance
3.1 Commissioning
1. Remove the machine from the packaging. Install the lithium battery, press and hold the power switch
for three seconds, and then release it. You should hear the sound of two beeps; this means that the
battery is normally charged.
2. Continuously and quickly press the trigger twice to automatically open the blade.
3. Before starting work, press the trigger to operate the blade several times and listen for unusual noises
or too fast or too slow working speed. If everything is normal, you can start working.
4. Off: Press the trigger and release it after hearing a beep three times. The blade will close
automatically.
3.2 Tips for use
Note: (1) The machine may overheat after a long time of use, this is a normal phenomenon. Let the
machine cool down for a while and you can use it again when the temperature drops.
(2) After completing the pruning work, at the end of the season, or when you replace the blade, and need
to remove the blade, add lubricating oil for the maintenance of the blade and the cutting system.
While pruning, start pruning about 8mm from the bud; the maximum cutting diameter is
30mm.
Prune in the part furthest from the bud to avoid loss of sap in the plant.
Do not prune the branches too far away from the tree, as it will reduce the health of the
plant. Leave a small section of the branch to avoid stress on the plant.
While working with the scissors, keep your hands away from the cutting blades and equip
suitable gloves and protective equipment.
Remove diseased shoots and remove dry branches on the plant.
When pruning a tree, prune each branch separately and do not cut multiple branches at
once.
3.3 Battery charging
The battery in a new machine is not fully charged. Before charging,
insert the battery into the charger and insert the charger plug into the
outlet. As shown in the image to the right, the red indicator light shows that
the battery is charging; the green indicator light indicates that the battery is
charged. Use the scissors after full battery charges.
3.4 Special attention
1. Before charging, turn off the switch; During charging, it is normal to have a slightly warm charger and
batteries.
2. If the batteries are not used for a long time, they should be recharged every 3 months to increase the
service life;
3. New batteries or batteries not used for a long time will reach the maximum capacity after 5 times of
charge-discharge cycles;
4. Do not charge the batteries repeatedly after several minutes of operation, this may reduce the working
time and the effectiveness of the batteries.