DS Services of America pure water dispenser 200k Series Manual do Proprietário - Página 3

Procurar online ou descarregar pdf Manual do Proprietário para Dispensador de água DS Services of America pure water dispenser 200k Series. DS Services of America pure water dispenser 200k Series 6 páginas. Diy: how to clean your water dispenser
Também para DS Services of America pure water dispenser 200k Series: Como limpar (2 páginas)

Imprimir página

CHILD SAFETY

CAUTION:

Supervise children when using the dispenser.

The hot dispenser faucet is equipped with a child

safeguard that reduces the risk of hot water being

dispensed accidentally or by small children. To

dispense hot water, simultaneously depress the

child safety lock (located above the left hot faucet

handle) and the left hot faucet handle. Do not allow

children to hang, climb or stand on the dispenser;

the dispenser could fall over and the child could be

injured.

RECEIVING

Inspect the dispenser box carefully for any evidence of shipping or handling damage before signing to receive goods. In case of

shipping damage, claims should be filed immediately with the carrier.

HOW TO INSTALL AND USE

WARNING:

Read through every step in HOW TO INSTALL AND USE before plugging in or turning unit on.

1. Install dispenser on a level floor strong enough to support it when fully loaded.

2. Ensure dispenser stands upright for a minimum of 2 hours before loading water bottle, plugging in and turning on dispenser.

3. Keep dispenser unplugged and in the off position until the water bottle has been loaded and water flows through the faucets.

4. Place dispenser a minimum of 2 inches away from the wall to ensure ventilation.

5. Do not install dispenser where it will be subject to direct sunlight, heat or moisture.

6. Do not install dispenser where the temperature will go below 50 º F (10 º C) or above 100 º F (38 º C).

7. Wipe down the water bottle cap and neck to ensure there is no debris.

8. Remove tamper-evident seal from plastic

bottle cap. Do NOT remove plastic cap if

using a no-spill water bottle.

NOTE:

Be sure to use a no-spill water bottle.

Using bottles without the no-spill feature

can cause leaking to occur.

9. Load water bottle by lifting and inserting it

onto the probe, ensuring bottle is fully aligned

with the dispenser and centered over the probe.

Be certain fingers and other body parts are

clear of underside of bottle. Apply slight

pressure until the plug inside the cap pushes

in and the bottle is seated. Water will begin

to flow into the tank causing air bubbles

in the bottle.

Caution:

When loading bottle, lift

with legs to prevent injury.