Daintree GE current Immersion GELP24-100U-GLX Manual de instalação - Página 3
Procurar online ou descarregar pdf Manual de instalação para Equipamento de iluminação Daintree GE current Immersion GELP24-100U-GLX. Daintree GE current Immersion GELP24-100U-GLX 3 páginas. Led refrigerated display lighting 93077673 100w led driver
Imprimir página
Immersion
GELP24-100U-GLX Driver
TM
3
Connection Configurations
For information on A, B, C, see Steps 1 and 2.
Refer to LED Light Bar installation instructions for
LED light bar wiring configurations.
Remote Mounting Distance
100W Power Supply
Troubleshooting
Symptom
Solution
•
All LED lights are OFF
•
•
•
•
•
Some LEDs appear dim
•
Some of the LED lights
are not illuminated
•
18 AWG/0.82 mm
16 AWG/1.31 mm
2
Supply Wire
20 ft./6.1 m
The GELP24-100UGLX features a new built in output overload shutdown feature that automatically
resets when the AC supply is removed and reapplied. So if all LED lights are off, first verify whether or
not the output can be reset by first switching off then switching back on the AC supply. If the LED lights
do not re-light, then proceed to the following solutions.
Check AC input connection and/or check circuit breaker.
Check wire connection(s) at the LED System and power supply for improper termination(s) or short
circuits. Properly terminate or replace the wire connection(s).
Check that connections are the (+) wire of the LED light to the (+) wire of the power supply and the (-)
wire of the LED light to the (-) wire of the power supply.
Ensure the overall LED load does not exceed the maximum load. If so, remove the excess load, and
cycle the AC supply to reset the drivers built in overload protection.
Ensure the length of supply wire is equal to or below the recommended remote mounting distance.
Check wire connection(s) at the LED light and power supply for improper termination(s) or short circuits.
Properly terminate or replace the wire connection(s).
Check that connections are the (+) wire of the LED light to the (+) wire of the power supply and the (-)
wire of the LED light to the (-) wire of the power supply.
www.gecurrent.com
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
DISP105 (Rev 10/27/21)
Typical Installation
14 AWG/2.08 mm
2
Supply Wire
Supply Wire
25 ft./7.6 m
35 ft./10.6 m
Installation Guide
TERMINAL BLOCK
(AC SOURCE)
12 AWG/3.31 mm
2
Supply Wire
40 ft./12.1 m
2