DS18 CANDY-X1B Manual do Proprietário

Procurar online ou descarregar pdf Manual do Proprietário para Subwoofer DS18 CANDY-X1B. DS18 CANDY-X1B 3 páginas. Monoblock subwoofer / stereo full range class d amplifiers
Também para DS18 CANDY-X1B: Manual do Proprietário (16 páginas), Manual do Proprietário (16 páginas)

Imprimir página
DS18 CANDY-X1B Manual do Proprietário
TROUBLESHOOTING
Before removing your amplifier.refer to the list below and follow the
suggested procedures. Always test the speakers and their wires first.
AMPLIFIER WILL NOT POWER
UP.
Check for good ground connection
.
Check that remote DC terminal has at least 1 OV DC
.
Check that there is battery power on the+ terminal.
Check all FUSES.
Check that Protection LED
is
not lit.If
it
is lit, shut off amplifier briefly and then repower it.
HIGH HISS OR ENGINE NOISE(ALTERNATOR WHINE) IN
SPEAKERS.
Disconnect all RCA inputs to the
amplifier,
if hiss/noise disappears ,then
plug in the component driving the amplifier and unplug its inputs
.
If hiss/
noise disappears, go on until the faulty/noisy component is found.
It is best to set the amplifier input level as insensitive as possible.The best
subjective S/N ratio is obtainable this way .Try to drive as high a signal level
from the head unit as possible.
PROTECTION LED COMES ON WHEN THE AMPLIFIER IS POWERED
UP.
Check for shorts on speaker leads.
Check that volume control on the head unit is turned down low.
Remove
speaker
leads ,and reset the amplifier. If the Protection LED still comes on ,
then the amplifier is faulty.
The amplifier will shut down automatically when the units· temperature goes up to
as•c
This will protect the units from damage.
AMPLIFIER'S GETS VERY
HOT.
Check that the minimum speaker impedance for that model is correct.
Check for speaker shorts.
Check that there is good airflow around the amplifier.In some applications,
an external cooling fan may be required
.
DISTORTED SOUND
.
Check that the Level control's is set to match the signal level of the head unit.
Check that all crossover frequencies have been properly set
.
Check for shorts on the speaker leads.
HIGH SQUEAL NOISE FROM
SPEAKERS.
This is always caused by a poorly grounded RCA patch cord.
WARNING!
1.
Over high volume will damage your
speakers.
2.
Be cautious when you use the amplifier near gasoline tank and electric
wires.
3.
Protect the connecting wires and parts to avoid any damage or short circuit.
4.
The power must belee from the anode of the battery via FUSE.
5. The sound system must be in turning-off situation when you check the amplifier.
6.
Be sure that you use the same type of FUSE when you need to replace it
.
•
We reserve the right to make needed change or improvement to the
product,
without informing customer about this in
advance.
US1B1
CFINDY-><18
□ WNER'S
MANUAL
WE Lll-<E IT
L□ UD
>
C
z
a:
u